..., the results of the well modeling exercise show that for the range of parameters used in the evaluation, predicted WHFT varies between 51°C and 138°C. This range was used as an input for the modeling of the ORC unit performance. Upon completing initial sensitivity assessment, multiple simulation runs were...

...) Figure 3 Footprint comparison of VTs and MDA at inlet water flow rate of 100 m 3 /h Figure 6 Life-cycle costs assessment (LCC) comparison between MDA and VT (as Total life-cycle costs vs Capacity) at different MDA's frequency of replacing the contactors. Figure 7 Effect of frequency...

... Material Selection & Corrosion Risk Assessment Typical cost comparison for different pipeline material Company Lesson Learned Challenges of non-metallic pipeline and Cost Benefit analysis Key challenges, advantages and disadvantages for GRE and CS with HDPE liner pipeline GRE...

... Table 1 Produced water reinjection (PWRI) risk assessment scopes and the expected outcomes. Workscope Outcome Use of outcome Injectivity study Produced water quality parameter for reinjection (OIW, TSS, particle size) Specification for surface facility design Scaling...

... Risk Filter 10. Assumption for Risk Quantification (Risk Parameter) Figure 1 Diagram of Company Water Risk Assessment Tool Abstract This paper introduces the company's novel Water Related Risk Assessment Tool, a bespoke risk-based approach to water management within oil...

..., and oil desalting process rather than disposal in the ponds. A comprehensive water conservation assessment was conducted where multiple waste streams were identified and evaluated against alternatives destination and desired water quality. Following the assessment, the RO reject and steam generation...