1-20 of 933 Search Results for

Stub

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Images
Permanent P&amp;amp;A as per CFR 30.250 for a casing <b>stub</b> where the <b>stub</b> end is...
Published: 15 October 2013
Figure 3 Permanent P&amp;A as per CFR 30.250 for a casing stub where the stub end is within the casing and a subsea well with unsealed annulus More
Images
(a) Proppants adhered to an aluminum <b>stub</b> with double-sided adhesive carbon...
Published: 10 February 2021
Fig. 2 (a) Proppants adhered to an aluminum stub with double-sided adhesive carbon tape; (b) backscattered image of resin-coated 20/40-mesh-sand proppants without GNP coating used in EDS analysis. More
Images
Single cement plug across multi casing <b>stub</b>
Published: 16 March 2021
Figure 2 Single cement plug across multi casing stub More
Images
Schematic of sample mounted on a <b>stub</b> relative to the orientation of the io...
Published: 23 February 2010
Fig. 16 Schematic of sample mounted on a stub relative to the orientation of the ion and electron beams. The cut surface, the dashed red line is at an angle of about 52° to the electron beam. More
Images
Images
Images
Case study MLS well: a) suspended well with MLS and <b>stub</b>; b) well after tie...
Published: 25 February 2020
Figure 4 Case study MLS well: a) suspended well with MLS and stub; b) well after tieback and completion More
Images
Images
Proceedings Papers

Paper presented at the SPE European Petroleum Conference, October 24–27, 1978
Paper Number: SPE-8052-MS
... penetration test installation penetration penetration resistance dome EUR 14 INSTALLATION OF THE ELF TCP2 CONDEEP PLATFORM AT THE FRIGG FIELD by Oddvar Kjekstad, Norwegian Geotechnical Institute, and Finn Stub, Norwegian Contractors © Copyright 1978, European Offshore Petroleum Conference...
Proceedings Papers

Paper presented at the Offshore Mediterranean Conference and Exhibition, March 28–30, 2007
Paper Number: OMC-2007-012
... and platform settlement; * the riser stubs, exiting the platform wall, has to be protected from ice impact; * no dredging is allowed closer than 15m from platform wall due to platform stability and safety reason; * very tight schedule for design, material procurement, fabrication and installation...
Proceedings Papers

Paper presented at the CORROSION 2003, March 16–20, 2003
Paper Number: NACE-03491
... (HAZ) at the tube-to-stub end weld at the discharge header. The high hardness was attributed to a line of arc strikes and weld spatter along the HAZ on the tube side of the weld joint. The weld spatter was found to have a composition of 73 percent nickel and 12 percent chromium. HAZ hardness under...
Journal Articles
J Pet Technol 15 (11): 1171–1179.
Paper Number: SPE-634-PA
Published: 01 November 1963
..., and at a convenient time this platform was installed over the submerged stub by a standard derrick barge. A 48-in. diameter steel tube - "snorkel tube" - was lowered through guides within the platform, over the stub and on to the ocean floor. The tube then was driven to refusal with a large pile driver, and water...
Journal Articles
Journal: SPE Journal
SPE J. 26 (03): 1402–1421.
Paper Number: SPE-203825-PA
Published: 16 June 2021
Proceedings Papers

Paper presented at the CORROSION 2021, April 19–30, 2021
Paper Number: NACE-2021-16410
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 5–8, 1986
Paper Number: OTC-5138-MS
... are required to be compact and to use tapered wall section from the production technology point of view. As a solution, overlapped cast steel nodes with 3 degrees of taper in the wall thickness of the stubs can be proposed. The structural characteristics of the overlapped nodes, and the design formulae...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 5–8, 1986
Paper Number: OTC-5350-MS
... ABSTRACT Four stub column tests were conducted for the purpose of making a direct comparison of the effects of pinholes and stress relieving on axial load-deformation behavior. Theoretical analysis of a stress relieved tubular column with pinholes was performed using the finite element method...
Proceedings Papers

Paper presented at the Offshore Technology Conference Asia, November 2–August 19, 2020
Paper Number: OTC-30270-MS
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201256-MS
Proceedings Papers

Paper presented at the SPE International Conference on Health, Safety, and Environment in Oil and Gas Exploration and Production, March 29–31, 2004
Paper Number: SPE-86796-MS
... and offshore environments. Before this directive, our company operations had commenced a comprehensive effort in 1999 to address these sites. Across the Nigerian Niger Delta, abandoned drill locations (including well stubs) number well over several tens of thousands. The Niger Delta area of the country lies...

Product(s) added to cart

Close Modal