1-20 of 37023 Search Results for

Elevators

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
OIJ 2017 (04): 96–99.
Paper Number: OIJ-2017-04-096-099-RU
Published: 01 April 2017
... of complex architecture with two horizontal shafts and selective operation of each trunk using the technology of simultaneous – separate operation with two elevators. Only domestic equipment (together with whipstock) is used during the process of construction, well completion and operation. Comparative...
Images
The casing-drive tool includes single-joint <b>elevators</b> that are used to pick...
Published: 19 September 2006
Fig. 2 The casing-drive tool includes single-joint elevators that are used to pick up joints of casing from the V-door and align them vertically with the drive-tool spear and grapples. More
Images
Mechanized <b>elevators</b> are used to grip and lift joints of casing from the V-...
Published: 19 September 2006
Fig. 3 Mechanized elevators are used to grip and lift joints of casing from the V-door. More
Images
32-in. caisson being run with 32-in. <b>elevators</b>.
Published: 16 April 2012
Figure 9 32-in. caisson being run with 32-in. elevators. More
Images
Drill Pipe is free hanging from top drive, not <b>elevators</b>. Greater than 1&#x27; m...
Published: 14 March 2017
Figure 1 Drill Pipe is free hanging from top drive, not elevators. Greater than 1' misalignment from rotary and stack center. More
Images
The Downhole System being Picked Up in the <b>Elevators</b> to RIH
Published: 25 August 2013
Figure 8 The Downhole System being Picked Up in the Elevators to RIH More
Images
(left) The Downhole System being Picked Up in the <b>Elevators</b> to RIH
Published: 11 June 2013
Figure 10 (left) The Downhole System being Picked Up in the Elevators to RIH More
Images
&quot;InSlips&quot; Threshold change. <b>Elevators</b> versus Top Drive
Published: 09 November 2020
Figure 6 "InSlips" Threshold change. Elevators versus Top Drive More
Images
Trip on <b>Elevators</b>: no held ups, over pull or back reaming required while tr...
Published: 08 March 2021
Figure 11 Trip on Elevators: no held ups, over pull or back reaming required while trip out in the open hole. More
Images
Proceedings Papers

Publisher: Society of Petroleum Engineers (SPE)
Paper presented at the SPE International Conference on Oilfield Chemistry, December 6–7, 2021
Paper Number: SPE-204302-MS
.... Water baths filled with distilled water were used to cure the samples at atmospheric pressure and room temperatures of 25℃. For an elevated temperature of 75℃, the Precision TM Thermo Scientific water baths were used. A minimum of 3 samples was prepared and cured for 4 hrs, 6 hrs, 8 hrs, 1 day, 3 days...
Proceedings Papers

Paper presented at the SPE Nigeria Annual International Conference and Exhibition, August 2–4, 2021
Paper Number: SPE-207097-MS
... to form a thin, low-permeable filter cake. ( Reilly et. al, 2016 ). However, because of its insufficient rheological properties and the myriad of functions that a drilling fluid performs, it falls short of achieving total rheology and is unreliable at elevated temperatures. ( Amani et. al, 2012 ). A lot...
Journal Articles
SPE Drill & Compl 36 (02): 300–319.
Paper Number: SPE-199570-PA
Published: 16 June 2021
...-dependent material properties have on pipe body and connection performance in HP/HT applications. This paper raises an awareness of the importance of strain-rate effects, and recommendations are made on a few special considerations to account for these effects in well tubular design for elevated temperature...
Proceedings Papers

Paper presented at the CORROSION 2021, April 19–30, 2021
Paper Number: NACE-2021-16547
... susceptibility at different concentrations of statistically significant chemicals in the waste up to 75 °C. Using the results of this study, the pitting factor was analyzed and validated for elevated temperatures. Introduction The Hanford Site in Washington State currently stores millions of liters...
Journal Articles
SPE Res Eval & Eng 24 (01): 1–18.
Paper Number: SPE-200324-PA
Published: 10 February 2021
... dynamics carbonate core half-life injection water experiment application elevated temperature reservoir degradation spe reservoir evaluation A significant fraction of the oil that could be recovered by polymer flooding and other chemical‐flooding methods exists in hot carbonate reservoirs...
Journal Articles
Journal: SPE Journal
SPE J. 25 (06): 2915–2931.
Paper Number: SPE-201240-PA
Published: 17 December 2020
...Zehua Chen; Zulong Zhao; Daoyong Yang Summary Accurate quantification of phase behavior of solvent/heavy-oil/bitumen/water systems at high pressures and elevated temperatures is of high significance for the design of vapor extraction, cyclic solvent injection, expanding‐solvent steam‐assisted...
Includes: Supplementary Content
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201611-MS
... that NG foams are well suited for fracturing applications. Like other foams, NG foam exhibits sensitivity to operating temperature characterized by a decrease in apparent viscosity as temperature increases. Rapid foam breakdown was observed at significantly elevated temperatures exceeding 290°F...
Proceedings Papers

Paper presented at the SEG International Exposition and Annual Meeting, October 11–16, 2020
Paper Number: SEG-2020-3422791
... situations and environments by significantly reducing the fieldwork load and reasonably planning implementation route, both reducing the construction risk and improving the survey efficiency. With the application of high precision remote sensing information, especially the DEM (digital elevation model), many...
Proceedings Papers

Paper presented at the The 30th International Ocean and Polar Engineering Conference, October 11–16, 2020
Paper Number: ISOPE-I-20-1209
... ABSTRACT In this study, a new integrated methodology (WLRSM) for mapping tidal flats elevation is proposed, which integrates the waterline (WL) method and remotely sensed moisture (RSM) method. Level-1 DEM of tidal flats is provided by WL, and then improved furtherly by RSM. The level-1 DEM...
Proceedings Papers

Paper presented at the The 30th International Ocean and Polar Engineering Conference, October 11–16, 2020
Paper Number: ISOPE-I-20-3109
... the surface elevation around array of truncated cylinders are investigated. The influence of the distance between cylinders, wave directions, scatter parameter and wave steepness are examined. Based on the potential theory, the first-order and the second-order surface elevation are calculated...

Product(s) added to cart

Close Modal