1-20 of 101 Search Results for

Brick pattern/en

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the The 29th International Ocean and Polar Engineering Conference, June 16–21, 2019
Paper Number: ISOPE-I-19-456
... of composite mortar and nine blocks of red brick in a crisscross pattern. The specimens are shown in Fig.1. To make a comparison, the M5.0 and M7.5 were selected and masonry shear specimens were made with red bricks and composite mortars with different strength grades (M5.0 and M7.5). The twin shear method...
Proceedings Papers

Paper presented at the 1996 SEG Annual Meeting, November 10–15, 1996
Paper Number: SEG-1996-0786
... to interpret. Geophysical prospection aimed to investigate the so far unknown settlement pattern and detect architectural remains. Magnetic prospecting of the stone architecture turned out to be excellent due to a high amount of contrast between the volcanic rock and the sedimentary fill. A fluxgate...
Proceedings Papers

Paper presented at the 10th ISRM Congress, September 8–12, 2003
Paper Number: ISRM-10CONGRESS-2003-163
.... Zur Interpretation der gewonnenen Informationen wurden komplexe 3D Modelle entwickelt, die eine Simulation des Bauablaufs und die Anwendung nichtlinearer Stoffgesetze fuer die verschiedenen Formationen und Aussteifungssysteme ermöglichten. Le Tunnel ferroviaire du Rossio a ete construit en 1890...
Proceedings Papers

Paper presented at the 44th U.S. Rock Mechanics Symposium and 5th U.S.-Canada Rock Mechanics Symposium, June 27–30, 2010
Paper Number: ARMA-10-510
... loading conditions. A commercially available model material, sand-lime brick was used to simulate a weak rock material. Properties of this model material are presented in Table 1. The bricks of the model material were cut into small elemental blocks of size 25 × 25 × 25 mm, and these blocks were assembled...
Proceedings Papers

Paper presented at the The 42nd U.S. Rock Mechanics Symposium (USRMS), June 29–July 2, 2008
Paper Number: ARMA-08-074
... of the critical conditions triggering kink band instabilities in fractured rock masses. This happens under particular condition of loading path, joint pattern geometry, joint relative orientation to the stress tensor, joint spacing relative to their length and the stress level. Very few theoretical studies were...
Proceedings Papers

Paper presented at the The Twenty-fifth International Ocean and Polar Engineering Conference, June 21–26, 2015
Paper Number: ISOPE-I-15-763
... and tidal currents. The validated model was then used to investigate the spatial and temporal patterns of mixing and transport in different channels. Model results show that: the pattern of mixing and transport is reciprocating straight lines during neap tides for all channels, while it is both...
Proceedings Papers

Paper presented at the ISRM International Symposium - Rockstore 80, June 23–27, 1980
Paper Number: ISRM-Rockstore-1980-021
... Blumenthal ~n Allemagne. C'est une methode par le revetement en beton projete, des anneaux d"'appui et des bou Lorrs d'ancrage, fixes dans la roche apres le deblaiement du rocher. KEYWORDS Coal mining, underground inetallation, shotcrete~ doub~e -she~l support, single shell support, convergence movements...
Proceedings Papers

Paper presented at the SPE International Health, Safety & Environment Conference, April 2–4, 2006
Paper Number: SPE-98550-MS
... was to use the encapsulated material as brick or tiles by the building industry. Drilling cuttings from Recôncavo Region consists mainly of a clayey soil mixed with n-parafin, chlorine and barite. They present and high percentage of clay fraction, in which ilite and kaolinite are the main clay minerals...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 7–9, 1984
Paper Number: OTC-4801-MS
... Drilling System: Super Series (Super CIDS) by S.B. Wetmore, Global Marine Development Inc. This paper was presented at the 16th Annua] OTC in Houston, Texas, May 7-9, 1984. The material is -subject to correction by the author, Permission to copy is restricted to en abstract of not more than 300 words...
Proceedings Papers

Paper presented at the The 4th U.S. Symposium on Rock Mechanics (USRMS), March 30–April 1, 1961
Paper Number: ARMA-61-059
... the contours of the cap rock of the salt dome which is approximately circular in outline. The rocks constituting the cap rock--gypsum, anhy- drite, and brecciated limestone--have little in- fluence on the pattern of surface subsidence since the production is from their uppermost re- gions. The strata overlying...
Proceedings Papers

Paper presented at the 4th ISRM Congress, September 2–8, 1979
Paper Number: ISRM-4CONGRESS-1979-145
... as the electrical reference for the measurements. 3. SPECIMENS AND PREPARATION A variety of natural m~nerals, coal, oil shale and red brick were tested to see if the general phenomena reported here was present. In general this was the case suggesting that the effects are likely to be observed in most rock/ceramic...
Proceedings Papers

Paper presented at the 7th World Petroleum Congress, April 2–9, 1967
Paper Number: WPC-12111
.... Rate of production of the wells is up to 80-100 t/d while 5 mm choke and gas factor 30-40 m3/ton. Oil is of 0.84-0.89 gravity with content of sulphur 0*5%, paraffin to 8%. 69 promising local structures are known within the Prepyatsky depression. Résumé La découverte en 1964 dans le Sud-Ouest de la...
Journal Articles
J Pet Technol 12 (04): 11–15.
Paper Number: SPE-1391-G
Published: 01 April 1960
... and distribution of reservoir nonuniformities, well pattern effects, and gravity effects caused by the density difference between the oil and the injected fluid. 1 4 1960 1 4 1960 1 4 1960 1 4 1960 1960. Original copyright American Institute of Mining, Metallurgical, and Petroleum...
Proceedings Papers

Paper presented at the 9th ISRM Congress, August 25–28, 1999
Paper Number: ISRM-9CONGRESS-1999-239
... sur 39 tirs sous-sol. Quelques respondes structurelles aussi etais obtenu L'amplitude de vibration ete controle en mine temps a la terre et aussi aus etage differentes de la structure, On a note que la vitesse particulaire diminue avec augmentation de la hauter de la structure. Dans le case d'abattage...
Journal Articles
Mar Technol SNAME N 40 (02): 82–92.
Paper Number: SNAME-MTSN-2003-40-2-82
Published: 01 April 2003
... with common finite element modeling practice. Figure 5 shows a side view of the rivets (without the at- tached plate elements), showing the three ways in which riv- ets were represented in our models. The rivet on the left consists of eight-node brick elements, used to visualize the path of the stresses...
Proceedings Papers

Paper presented at the The Twenty-second International Offshore and Polar Engineering Conference, June 17–22, 2012
Paper Number: ISOPE-I-12-247
..., and eight- node reduced-integration brick elements (C3D8R) are used to simulate the surrounding soil. The top surface of the prism represents the soil surface, and the burial depth is chosen equal to about 2 pipe diameters, which is in accordance with pipeline engineering practice (Gresnigt,1986...
Proceedings Papers

Paper presented at the The 29th International Ocean and Polar Engineering Conference, June 16–21, 2019
Paper Number: ISOPE-I-19-195
... in shearing direction with a friction coefficient of tan where is the 284 friction angle of the sand. Because of the symmetricity of soil-pile system, half model was used to improve computing efficiency. The model was meshed using C3D8 element that is an 8-node linear brick element with three eight freedom...
Proceedings Papers

Paper presented at the ISRM International Symposium - 5th Asian Rock Mechanics Symposium, November 24–26, 2008
Paper Number: ISRM-ARMS5-2008-067
... particles. Stones and bricks form the fabric of masonry structures. A contact of blocks may consist of a material, such as mortar in masonry, or it may be plain interactions of solid objects, such as joints in rock. The explicit modeling of these contacts, represented as structural discontinuities...
Journal Articles
Journal: SPE Journal
SPE J. 14 (03): 423–430.
Paper Number: SPE-110845-PA
Published: 15 July 2009
... point geometry (CPG) gridblocks are used to model reservoir fl ow with fi nite dif- ference method in the reservoir fl ow module, while eight-noded brick-shaped elements are used for deformation simulation with fi nite element method in geomechanics module. The nodes of the brick-shaped elements...
Proceedings Papers

Paper presented at the 19th World Petroleum Congress, June 29–July 3, 2008
Paper Number: WPC-19-0256
... for crude oil demand in the coming years? Which is the type of crude oil that will be mostly available? Is there any room left for additional refining capacity in Europe? What are the demand pattern and quality requirements for the products of the refinery of the future? Answering these questions is nothing...

Product(s) added to cart

Close Modal