1-20 of 3657 Search Results for

Bottomhole pressure and temperature gauges

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
SPE Prod & Oper 3 (04): 637–642.
Paper Number: SPE-13988-PA
Published: 01 November 1988
.../temperature gauge (PTG) that provides a permanent bottomhole pressure/temperature gauge (PTG) that provides a continuous readout at surface. The gauge was installed primarily to monitor pump intake pressure and to avoid operation when the pressure falls below bubblepoint. Gauge specification and installation...
Proceedings Papers

Paper presented at the SPE Hydraulic Fracturing Technology Conference, February 9–11, 2016
Paper Number: SPE-179131-MS
... be placed at the desired depth to target the best rock for stimulation. Another benefit of CT fracturing is the ability to gather BH treating pressure via BH gauges (BHG) mounted on the CT bottomhole assembly (BHA). Bottomhole pressure and temperature gauges, installed above and below the isolation packer...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 6–9, 1996
Paper Number: SPE-36494-MS
... fracture fluid cleanup or, in the worst case, severe proppant pack conductivity damage. In an effort to confirm the design philosophy used in Piceance Basin Mesaverde treatments and to examine heat transfer in hydraulic fracturing treatments, bottomhole pressure and temperature gauges were set...
Journal Articles
J Pet Technol 72 (03): 57–58.
Paper Number: SPE-0320-0057-JPT
Published: 01 March 2020
... time by using upstream-choke, bottomhole-pressure, and temperature-gauge data. The algorithms performed dynamic pressure-gradient calculations to find optimal solution rates to match physical sensor readings. The daily back-allocation methodology at well level did not rely on well rate measurements...
Proceedings Papers

Paper presented at the SPE/ICoTA Coiled Tubing & Well Intervention Conference and Exhibition, March 31–April 1, 2009
Paper Number: SPE-121696-MS
.... Formation of emulsions and asphaltenes were believed to be the cause of the production decline. However, with inadequate information, the diagnosis was inconclusive. Consequently, a fiber-optic-enabled coiled tubing string along with real-time bottomhole pressure and temperature gauges were used to acquire...
Journal Articles
SPE Prod & Oper 25 (02): 204–210.
Paper Number: SPE-121696-PA
Published: 11 March 2010
... chemical treatment was conducted and this time, a fiber-optic-enabled coiled-tubing (CT) string along with real-time bottomhole-pressure and temperature gauges were used to acquire distributed temperatures and pressures of the entire horizontal section of the wellbore. Results of the pressure survey...
Images
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 27–29, 2014
Paper Number: SPE-170598-MS
... in the choke example. The flowing bottomhole pressure and temperature gauges are similar to the downstream pressure and temperature across the choke. However, it was recognized that the flowing bottomhole gauge is placed ~300 – 500 feet downstream of the completions. This vertical distance causes the following...
Proceedings Papers

Paper presented at the Brasil Offshore, June 14–17, 2011
Paper Number: SPE-142775-MS
... or incomplete consolidation of the treatments. In 1964, API introduced the first set of tables ( API 2005 ) that listed the circulating temperatures and hydrostatic pressures for certain wellbore circumstances and bottomhole conditions and the fluids that could be used in different well treatments...
Proceedings Papers

Paper presented at the IADC/SPE Asia Pacific Drilling Technology Conference and Exhibition, August 27–29, 2018
Paper Number: SPE-190980-MS
... bottomhole temperatures, high wellbore deviation, or mechanical obstructions that can prevent the use of downhole gauges in the well. This paper presents an innovative method for acquiring the needed bottomhole pressures in production wells when traditionally used methods may present challenges. An operator...
Proceedings Papers

Paper presented at the OTC Brasil, October 24–26, 2017
Paper Number: OTC-28088-MS
... wells in which downhole gauges are impractical or cost prohibitive, such as highly deviated, horizontal wells with tubing restrictions, sour-gas, high-pressure wells with high bottomhole temperatures, and low-cost evaluations. For mediumto high-permeability formations, a three-day test is typically...
Journal Articles
SPE Res Eval & Eng 21 (01): 31–38.
Paper Number: SPE-181546-PA
Published: 08 August 2017
... Simulation wellbore-fluid density top gauge contraction coefficient SPE Reservoir Evaluation Drillstem Testing friction pressure drop bottom gauge buildup period valve buildup reservoir nonisothermal effect packer estimation Until recently, bottomhole pressure and temperature were...
Proceedings Papers

Paper presented at the IADC/SPE Drilling Conference and Exhibition, February 2–4, 2010
Paper Number: SPE-128965-MS
... (HP/HT) wells. The definition of HP/HT well environments are those with bottomhole pressures above 10.000 psi and bottomhole temperatures above 300° F. When environments have bottomhole pressures above 15.000 psi and temperatures above 350° F, the wells are considered as extreme HP/HT. Until...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 3–6, 2010
Paper Number: OTC-21060-MS
... Obtained with Electronic Gauges. Fig.16 Tool String Used in Case 2. Fig. 15 Pressure Chart Obtained with Mechanical Gauges. Case 3 The third well was an offshore well tested with bottomhole temperatures between 338°F and 342°F. The test was run with a mechanical packer rated for 15 kpsi. The string used...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 26–28, 2016
Paper Number: SPE-181546-MS
... Abstract This paper discusses how the pressure measured by the downhole gauges during a drillstem test (DST) is affected not only by hydrostatic, friction or kinetic energy pressure losses, but also by changes in temperature. In oil wells, the bottomhole temperature is decreasing when...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, October 25–27, 2016
Paper Number: SPE-182329-MS
... conduction reservoir response temperature profile gas-condensate well equation hydrostatic head mid-completion bottomhole pressure bottomhole pressure gauge depth permeability composition gradient society of petroleum engineers convection heat capacity Pressure gauges are no longer...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 1–4, 2000
Paper Number: SPE-63079-MS
... as part of the completion. The system consisted of a fullbore mandrel with permanent pressure and temperature gauges and a wireline retrievable venturi sleeve. The gauges were connected to surface via an encapsulated single-conductor cable ported through the wellhead. The bottomhole data...
Journal Articles
J Pet Technol 64 (04): 130–135.
Paper Number: SPE-0412-0130-JPT
Published: 01 April 2012
.... Society of Petroleum Engineers drillstem/well testing sampler operation Drillstem Testing elastomer memory gauge Upstream Oil & Gas mechanical gauge envelope real time system bottomhole temperature best practice high-temperature environment mechanical pressure april 2012 procedure...
Proceedings Papers

Paper presented at the SPE/CSUR Unconventional Resources Conference, October 20–22, 2015
Paper Number: SPE-175974-MS
... Abstract A downhole force recorder is presented that uses onboard strain gauges along with temperature and pressure sensors to measure and record the forces experienced by a downhole assembly at the end of a coiled-tubing string. Field trials are discussed in order to demonstrate the benefits...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 5–8, 2003
Paper Number: SPE-84215-MS
... of the fracture treatment. Introduction The data presented here was collected from the bottomhole gauge data of 56 wells that were frac packed in the Gulf of Mexico, on the shelf or in shallow, inland waters. The bottomhole gauges were used to record bottomhole pressures and bottomhole temperatures...

Product(s) added to cart

Close Modal