Skip Nav Destination
Search Results for 5.4.2 Gas injection methods
1-10 of 10 Search Results for
5.4.2 Gas injection methods
S. Kobayashi, M. Soya, N. Takeuchi, J. Nobuto, A. Nakaya, T. Okuno, S. Shimada, T. Kaneto, T. Maejima
Paper presented at the ISRM Regional Symposium - EUROCK 2014, May 27–29, 2014
Paper Number: ISRM-EUROCK-2014-168
... arch and bench sections were treated with pre-grouting, and post-grouting as required, for forming an improved zone with lower permeability by means of injection around the cavern. For grouting around the cavern, various measures were taken for the grouting equipment, material and construction method...
Paper presented at the EUROPEC/EAGE Conference and Exhibition, June 8–11, 2009
Paper Number: SPE-121580-MS
... to layered formations. Ashoori et al. (2009) examine first-contact-miscible gas floods with foam, where there is only one non-aqueous phase present at any location. gas injection method enhanced recovery Upstream Oil & Gas Modeling & Simulation Fluid Dynamics flow in porous media...
Paper presented at the SPE Annual Technical Conference and Exhibition, October 9–11, 2017
Paper Number: SPE-187429-MS
... • Identified projects that are not yet approved Plant Capacity • Gas Injection* • Water Injection* • Lifting • Oil handling • Water handling • Gas handling • Limitations in oil, gas and water processing will result in a reduced Plant Capacity • Debottlenecking should increase Plant Capacity...
Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, April 20–22, 1999
Paper Number: SPE-54345-MS
... into four general categories: · Produced Water Produced water is extracted with the oil or gas produced. This is the largest volume waste generated by the oil and gas industry. In the U.S., produced water is primarily disposed of by injection to the subsurface in onshore operations. Majority of produced...
Paper presented at the International Petroleum Technology Conference, December 4–6, 2007
Paper Number: IPTC-11512-MS
..., separate gas caps and large lateral variations of oil properties across the field were captured in the initialisation of the simulation model. Dynamic flow properties in the reservoir are heavily dependent on wettability and oil properties and the paper describes the rigorous implementation of a complex...
Paper presented at the ISRM International Symposium - EUROCK 2013, October 23–26, 2013
Paper Number: ISRM-EUROCK-2013-001
... stress condition as well as the excavation geometry. Typical ground behaviors for underground structures are discussed and engineering design methods are presented. To deal with the uncertainties of the ground and the complexity of the subsurface buildings a behavior based design methodology is discussed...
Publisher: Pipeline Simulation Interest Group
Paper presented at the PSIG Annual Meeting, October 23–25, 2002
Paper Number: PSIG-0209
... Operation of the Huldra field commenced on November 2001. It is a gas condensate field, which has been developed with a not normally manned wellhead platform remotely controlled from the existing, manned Veslefrikk B platform. A first stage separation process is installed at the platform to separate gas...
Paper presented at the ISRM International Symposium, November 19–24, 2000
Paper Number: ISRM-IS-2000-003
..." is used frequently in both medicine (e.g., something such as a medicine or therapy that relieves pain or cures a disease) and law (e.g., a legal means of preventing or correcting a wrong or enforcing a right). Artificial Intelligence containment Upstream Oil & Gas reston remediation...
Paper presented at the European Petroleum Conference, November 16–18, 1992
Paper Number: SPE-25006-MS
... Abstract The ANGUILLE MARINE field has been produced for 25 years. Implementation of water injection soon revealed complex reservoir mechanisms controlled by severe sedimentary heterogeneities. The ANGUILLE Formation has been deposited in a deep-sea fan environment (slope apron) with a low...
Publisher: NACE International
Corrosion 59 (11).
Paper Number: NACE-03110931
Published: 01 November 2003
... Pipeline Corrosion riser corrosion materials and corrosion flowline corrosion Modeling & Simulation Upstream Oil & Gas chemistry corrosion secondary side steam generator nuclear power system stress corrosion alloy 600 critical review well integrity concentration Corrosion Science...
Product(s) added to cartClose Modal