1-20 of 15086 Search Results for

3.3 Well

Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE Europec/EAGE Annual Conference and Exhibition, June 12–15, 2006
Paper Number: SPE-100329-MS
... the reservoir affect water flooding. Sweep efficiency is related to these hard layers. Areas of unswept oil between these tight layers have been proved by reperforation of certain producing wells. In 1996 natural gas injection started into the gas cap which caused a reduction of the oil production decline...
Proceedings Papers

Paper presented at the CORROSION 2016, March 6–10, 2016
Paper Number: NACE-2016-7772
... industry is well documented.³ The microorganisms responsible for the most aggressive corrosion rates (CRs) are SRB.³ SRB produce hydrogen sulfide (H2S) from the reduction of sulfate with electrons from organic chemicals dissolved in oilfield waters. Although the sulfide produced by SRB is corrosive...
Proceedings Papers

Paper presented at the SPE Deepwater Drilling and Completions Conference, June 20–21, 2012
Paper Number: SPE-155426-MS
... and it was 10. Table 3 summarizes the drill-in fluid properties. Abstract Hydrochloric acid, organic acid, or a mixture of these acids is used to remove filter cake, which consists mainly of calcium carbonate. However, the use of these acids in horizontal and deep wells has some major disadvantages...
Proceedings Papers

Paper presented at the Abu Dhabi International Petroleum Exhibition and Conference, November 10–13, 2014
Paper Number: SPE-172033-MS
... for Thamama B calcite (δ 13 C: 2.8‰ to 3.9‰; δ 18 O: 4.6‰ to 5.9‰). Clumped isotope analyses indicate a most likely precipitation temperature of 65°C to 72°C and an isotopic composition of precipitating waters of 3.3‰ to 4.9‰ δ 18 O. Using a well calibrated basin model the temperature range places the depth...
Journal Articles
J Pet Technol 39 (02): 221–232.
Paper Number: SPE-13120-PA
Published: 01 February 1987
... was initiated in Spring 1981 and was concluded in mid-1984. A total of 21 × 106 bbl [3.3 × 106 m3] of water was injected, and water breakthrough occurred in two of the production wells. Simulation of waterflood performance in the pilot was conducted with a three-dimensional (3D), three-phase dual-porosity model...
Proceedings Papers

Paper presented at the SPE Russian Petroleum Technology Conference, October 26–29, 2020
Paper Number: SPE-201842-MS
.... The work describes the development, laboratory evaluation, implementation and long-term assessment of self-healing properties for H 2 S/CO 2 resistive, low Young's modulus, expandable cement system. The 2.05 SG cement system was specially designed and implemented on 12 wells at N oil field for guaranteed...
Journal Articles
SPE Res Eng 12 (01): 37–44.
Paper Number: SPE-28577-PA
Published: 01 February 1997
... the observation of a varying water salinity in this reservoir. Twenty-seven wells in this field were cored with an oil-based mud (OBM) at locations chosen to provide good areal coverage over this 225-sq-mile reservoir. More than 2,000 measurements of the water chlorinity were made on Ivishak core samples from...
Journal Articles
SPE Form Eval 7 (03): 261–267.
Paper Number: SPE-21412-PA
Published: 01 September 1992
...G.N. Salaita Summary Three generations of SchIumberger's Thermal Decay Time (TDT SM ) logging devices - viz., TDT-K, TDT-M, and TDT-P - along with an Atlas Wireline PDK-100 SM system were run ins Saudi Aramco well. The wellbore (8 1/2 in. with 7-in. casing) penetrated a sequence of clean sand...
Proceedings Papers

Paper presented at the SPE Improved Oil Recovery Conference, August 31–September 4, 2020
Paper Number: SPE-200443-MS
...-4, the average single well perforated sandstone thickness is 18.98m, the effective thickness is 12.95m, and the average effective permeability is 0.596μm 2 , Pu I 2 oil layer has the best development results ( Table.2 ). Figure 3 Relationship between concentration and viscosity...
Proceedings Papers

Paper presented at the SPE International Oilfield Corrosion Conference and Exhibition, June 16–17, 2021
Paper Number: SPE-205044-MS
... aims to evaluate the influence of real rock cuttings sizes and concentration as well as we investigate the effect of base fluid type on the erosion-corrosion rate. Actual drilled cuttings have been sieved to get three sizes of erodent cuttings; namely, 0.841 to 3.3 mm. Experiments are done with three...
Journal Articles
J Pet Technol 40 (11): 1469–1476.
Paper Number: SPE-15570-PA
Published: 01 November 1988
... of water-injection wells are discussed in terms of completions, downhole equipment, and stimulation. An extensive realignment project involving an active drilling program is currently under way in the Vickers East pool. Introduction The Vickers East pool is located in the Los Angeles basin. One of several...
Proceedings Papers

Paper presented at the International Oil and Gas Conference and Exhibition in China, November 7–10, 2000
Paper Number: SPE-64637-MS
... a priori to evaluate the environmental impact of reserve pits. The pit was equipped with neutron probe access tubes, barrel size lysimeters, vacuum extraction moisture cups and gypsum resistively blocks at 4 stations within the pit perimeter. Ground water monitoring wells, and post closure soil borings...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 1–4, 2000
Paper Number: SPE-63242-MS
... agent for use in oilfield services. The materials evaluated include hydroxy-aminopolycarboxylic acids (HACA) such as hydroxyethylethylenediaminetriacetic acid (HEDTA) and hydroxyethyliminodiacetic acid (HEIDA) as well as other types of chelating agents. Introduction Chelating agents have been used...
Proceedings Papers

Paper presented at the CORROSION 98, March 22–27, 1998
Paper Number: NACE-98483
... correlated to alloy performance under specific flue gas desulfurization (FGD) conditions of temperature, chloride, and pH. Quantitative correlations have now been developed between the extended PRE parameter (PREJ-which includes the effects of nitrogen and tungsten as well...
Journal Articles
J Pet Technol 17 (03): 343–347.
Paper Number: SPE-955-PA
Published: 01 March 1965
... of 1960 and 1961, ignition, and, finally, operation of the test. The Fry combustion project was a pilot test of cocurrent in situ combustion on a 3.3-acre inverted five-spot. In the summer of 1960, air injection tests were conducted using old wells in the area and a new air injection well drilled...
Journal Articles
J Pet Technol 29 (07): 771–775.
Paper Number: SPE-6110-PA
Published: 01 July 1977
... techniques. Estimates of oil in place in known formations (as well as estimates of undiscovered reserves) promise that petroleum's role in our national energy picture is far from played out. In fact, petroleum will remain the mainstay of our energy petroleum will remain the mainstay of our energy economy...
Journal Articles
J Pet Technol 71 (11): 54–56.
Paper Number: SPE-1119-0054-JPT
Published: 01 November 2019
..., indicating a high degree of brittleness as well as low water sensitivity. Fig.• 1 shows a sequence of scanning electron microscope (SEM) images in which Image A is equivalent to 7,000x magnification and Image B shows a 30,000x magnification with respect to the original sample size. The SEM images suggested...
Proceedings Papers

Paper presented at the SPE Kuwait Oil & Gas Show and Conference, October 13–16, 2019
Paper Number: SPE-198101-MS
... to be above the groundwater level, as well as, providing stormwater drainage system of the refinery to be a gravity drained, which will save major capital cost. KNPC (Former Owner of the Project) has contracted with M/s Van Oord to perform the Ground Remediation and Site Preparation for the project site...

Product(s) added to cart

Close Modal