Review of Waterflood Performance in the Fosterton Main Unit
- D.W. Tutt (Socony Mobil Oil of Canada Ltd.)
- Document ID
- Petroleum Society of Canada
- Journal of Canadian Petroleum Technology
- Publication Date
- April 1966
- Document Type
- Journal Paper
- 55 - 61
- 1966.Petroleum Society of Canada
- 5.3.4 Reduction of Residual Oil Saturation, 5.2.1 Phase Behavior and PVT Measurements, 4.6 Natural Gas, 5.3.2 Multiphase Flow, 1.6 Drilling Operations, 6.5.2 Water use, produced water discharge and disposal, 5.1.1 Exploration, Development, Structural Geology, 5.4.1 Waterflooding, 2.1.3 Sand/Solids Control, 5.6.2 Core Analysis
- 1 in the last 30 days
- 185 since 2007
- Show more detail
- View rights & permissions
The Main Roseray sand pool is one of three pools comprising the Fostertonfield in southwestern Saskatchewan. The pool was discovered in January, 1952,by Mobil Oil Canada, Ltd. Drilling continued until the middle of 1955, whendevelopment was considered complete. The pool was unitized on July 1, 1958,with Mobil Oil Canada, Ltd. as the operator. Pressure maintenance by means ofwater injection commenced during March, 1959. This paper presents basic dataand a review of reservoir performance under pressure maintenance bywaterflooding in the Fosterton Main Unit.
The Main Roseray sand pool (Fosterton Main Unit) is one of three poolscomprising the Fosterton field. The Fosterton field is located in Township 17,Range 18, west of the Third Meridian in southwestern Saskatchewan (Figure1).
The pool was discovered in January, 1952, by Mobil Oil Canada, Ltd., by thedrilling of Socony-Western Prairie Fosterton No. 1 in Lsd. 2 of Section 10,Township 17, Range 18, west of the Third Meridian. The pool produces from astratigraphic trap in the Roseray sand created by an erosional unconformitybetween it and the overlying Blairmore formation. Drilling continued until themiddle of 1955, when development was considered complete. Production from thispool is obtained from the Roseray I sand and the Roseray II sand. Table 1presents the reservoir properties for the pool. Figure 2 is an isopachmap of the Roseray I sand, which is the lower of the two producing sands. Thissand extends from the western edge of the pool and gradually thins out to theeast about midway through Section 11. It is underlain by water in the northwestcorner and along the southern portion. There are approximately 36 MMSTB oforiginal oil-in-place in this sand. Figure 3 is an isopach map of theRoseray II sand. This sand extends from the western to the eastern edge of thepool. Approximately one-third of the oil-in-place in this sand is underlain bywater in the eastern portion of the pool, as shown by the shaded area.
|File Size||305 KB||Number of Pages||7|