... and N. Alizadeh. Experimental design in reservoir simulation: An integrated solution for uncertainty analysis, a case study. Journal of Petroleum Exploration and Production Technology, 2:75 83, 2012 (4) Y. S. Gurav, A. Y. Dandekar, S. L. Patil, and S. D. Patwardhan. Application of Design of Experiments...

... Liquid loading is the accumulation of liquid at the bottom of gas wells occurring at the end of field life. Surfactant injection is a common way to deliquefy these wells. In this work, a model of a sandbox, an inflow zone and a tubing is used to study deliquification. This experimental setup...

.... The experimental validation shows that the models are sufficiently accurate to make operational flushing decisions. fluid dynamics enhanced recovery inclination simulation reservoir surveillance experiment configuration production logging production monitoring pipe production control isavft ltd...

... to measurement uncertainties. Another advantage is that a CFD approach is able to assess multiple locations of fluid behaviors without incurring hardware or measurement sensor cost that would have been in the case of experiments. However, experimental validation is required to confirm the results of CFD...

... on these considerations, an experimental campaign was launched at the SINTEF Multiphase Flow Laboratory [16] to investigate the effect of water and the effect of surfactants. In the following section we present some of those experiments. 4 LABORATORY FLOW EXPERIMENTS The experiments were conducted using a 50 meter...

... flow ±0.03 for Intermittent flow ©ISAVFT Ltd. MPT 2023 53 3.1 Experimental Procedure The experiments were carried out by fixing the liquid velocity at the inlet and varying the gas velocities from high to low gas flow rate. The tested water superficial velocities are 0.01, 0.02, and 0.05 m/s...

... gas/liquid experimental study in near-horizontal pipes. Their study aimed to understand the effect of small pipe inclinations (± 2°) on pressure drop, liquid holdup, flow pattern, and liquid entrainment fraction. They used a pipe with a 50.8 mm inner diameter and conducted experiments using...

... to the experimental comparison. Figure 4: Average values for void in slug from post-processing of slug capturing (SC) simulations, compared to the predictions from the Unit-Cell Model (left), and against void in slug from post-processing of experiments (right). ©ISAVFT Ltd. MPT 2023 22 Figure 5: Average values...

... of numerical, modelling and experimental results In this section, the 2D numerical results are compared with both the modelling and experimental results. The physical model was developed by Ullmann & Brauner [2] and the experiments were obtained by Van Duin et al. [9]. The relationship between four hydraulic...