Surfactant-Polymer Flooding: Single Well Chemical Tracer Test Design and Implementation in a Major Sandstone Kuwaiti Reservoir
- Mohammed T. Al Murayri (Kuwait Oil Company) | Abrahim A. Hassan (Kuwait Oil Company) | Abdulla Abdul Rahim (Kuwait Oil Company) | Benoit Decroux (The EOR Alliance) | Andres Negre (The EOR Alliance) | Mathieu Salaun (The EOR Alliance)
- Document ID
- Society of Petroleum Engineers
- SPE Kuwait Oil & Gas Show and Conference, 13-16 October, Mishref, Kuwait
- Publication Date
- Document Type
- Conference Paper
- 2019. Society of Petroleum Engineers
- Sandstone Reservoir, EOR Pilot, Surfactant, Polymer, Kuwait
- 2 in the last 30 days
- 82 since 2007
- Show more detail
- View rights & permissions
|SPE Member Price:||USD 5.00|
|SPE Non-Member Price:||USD 28.00|
This paper discusses the design and implementation of a Single Well Chemical Tracer Test (SWCTT) to evaluate the efficacy of a lab-optimized surfactant-polymer formulation for the Raudhatain Lower Burgan (RALB) reservoir in North Kuwait.
A SWCTT was designed upon completing extensive lab and simulation work as discussed in a previous publication (Al-Murayri et al. 2017 and Al-Murayri et al. 2018). SWCTT design work was aimed at confirming the optimal injection/production sequence determined at core flood scale in terms of minimal volumes, rates and duration. The main uncertainties were assessed using numerous sensitivity scenarios. Afterwards, the SWCTT was implemented in the field and the results were carefully analyzed and compared to previously obtained lab andsimulation results.
The main objective of this SWCTT was to validate the efficacy of polymer and surfactant solutions in terms of residual oil saturation reduction and injectivity. This invovles comparing residual oil saturation estimates before and after chemical flooding while monitoring injection rates and corresponding wellhead pressures. The SWCTT injection sequence included the following steps:
Initial water-flooding, followed by tracer injection, soaking and production to measure oil saturation post water flooding.
Pre-flush followed by a main-slug (with 5,000 ppm of surfactant and 500 ppm of polymer) and a post-flush (with only polymer).
Sea-water push, followed by tracer injection, soaking and production to measure oil saturation post chemical flooding.
Simulation work prior to the execution of the SWCTT test showed encouraging oil desaturation results post chemical flooding within a distance of 10 ft from the well. However, upon analyzing the pilot results, it was realized that there is a gap between the actual SWCTT results and previously obtained lab andsimulation results. This paper sheds light on the design and implementation of the above-mentioned SWCTTwith emphasis on the potential reasons for the realized gap between actual field data and lab/simulation results. The insights from this study are expected to assist in further optimization of surfactant-polymer flooding to economically increase oil recovery from relatively mature reservoirs.
|File Size||917 KB||Number of Pages||17|
M.T. Al-Murayri, A.A., Hassan, M.B. Abdullah, and A.M. Abdulrahim, Kuwait Oil Company; C. Marliere, S. Hocine, and R. Tabary, The EOR Alliance. 2017. Surfactant-Polymer Flooding: Chemical Formulation Design and Evaluation for the Raudhatain Lower Burgan RALB Reservoir in Kuwait. SPE-183933-MS. Presented at the Middle East Oil & Gas Show and Conference held in Manama, Kingdom of Bahrain, 6-9 March 2017
M.T. Al-Murayri, A.A., Hassan, M.B. Abdullah, and A.M. Abdulrahim, Kuwait Oil Company; C. Marliere, S. Hocine, R. Tabary and G. Suzanne, The EOR Alliance. 2018. Surfactant-Polymer Flooding: Chemical Formulation Design and Evaluation for Raudhatain Lower Burgan RALB Reservoir, Kuwait. SPE-183933-PA. SPE Reservoir Evaluation & Engineering, October 2018.
M.T. Al-Murayri and A.A. Hassan, Kuwait Oil Company; I. Hénaut, C. Marliere and A. Mouret, IFPEN; D. Lalanne-Aulet, Solvay, J.P. Sanchez and G. Suzanne, Beicip-Franlab. 2019. Surfactant-Polymer Feasibility for a Sandstone Reservoir in Kuwait. Successful Integrated Approach from Laboratory to Pilot Design. SPE-194979-MS. Presented at the Middle East Oil & Gas Show and Conference held in Manama, Kingdom of Bahrain, 18-21 March 2019