Abstract

A new drilling method is in an advanced stage of development. It uses abrasive-laden jet streams to cut concentric grooves on the bottom of the hole being drilled. The ridges between grooves are then broken by contact with the drilling bit. Several important parameters which determine how rocks are cut by an abrasive-laden jet stream have been identified and measured. Abrasive jet bits have been built and used that apply as much as 5000 hp to the rock being drilled. Equipment and procedures for full-scale drilling have been developed, and three full-scale field tests of the new drilling process have been made.

These tests have verified the applicability of the basic data upon which the process is based. They have also shown that, in comparison with conventional rotary drilling, the penetration rate is as much as twenty times faster, and that the total penetration per bit is as much as seven times greater. The special high-pressure pumps developed to circulate a drilling mud that contains abrasive particles are adequate, but the equipment and procedures used to process the mud and abrasive need further development. The full potential of the drilling method has not yet been demonstrated in the field tests because of these equipment problems. Thus, the process offers still more opportunity for greater drilling rate and bit life than has been achieved. The data show that the application of abrasive jet drilling may cut drilling costs substantially, especially in deep and hard rocks.

Résumé

Une nouvelle méthode de forage est arrivée à un stade avancé dans son développement. Elle utilise des jets abrasifs pour couper des rainures concentriques au fond du trou de forage. Puis les crêtes entre les rainures sont eliminées mécaniquement. Beaucoup de paramètres importants concernant le percement de roches par jets abrasifs ont été identifiés et quantifiés.

Des trépans à jet abrasif ont été fabriqués et employés. Ces outils peuvent appliquer 5000 CV à la roche forée. L'équipement et des modes operatoires ont été développés pour des forages à l'échelle. Trois essais dans les conditions d'utilisation du nouveau procédé de forage ont été réalisés. Ces essais ont verifié l'applicabilité des principes fondamentaux sur lesquels la méthode est fondée. Ils ont aussi démontré qu'en comparaison avec le forage rotary conventionel le forage au jet abrasif est 20 fois plus rapide. On a aussi trouvé que des jets abrasifs percent jusqu'à sept fois plus de métrage par trépan. Les pompes spéciales mises au point pour comprimer le fluide de forage sont adéquates, mais l'équipement et les modes operatoires de traitement de la boue et de la matière solide abrasive nécessitent de travail d'amendement. Toute la puissance de la méthode n'a pas encore été dé- montré complétement par les essais d'utilisation parce qu'on a rencontré des problèmes d'équipement. De plus, la méthode offre d

This content is only available via PDF.
You can access this article if you purchase or spend a download.