... pressure complex reservoir fluid dynamics presented production monitoring production forecasting drillstem/well testing regime production data bottomhole pressure reasonable certainty upstream oil & gas calculation rate-transient analysis power-law behavior unconventional resource...

... such as spacing, orientation, and length are acquired and compared with regional or macroscopic elements. The main workflow of fracture network modeling consists of four main steps: fracture identification and density calculation, fracture driver characterization, discrete fracture network modeling and fracture...

... (flash) calculations to improve computational speed. Unlike previous publications that apply classical deep learning (DL) models to flash calculations, this work will demonstrate the first attempt to incorporate thermodynamics constraints into the training of these models to ensure that they honor...

... forecasting, economic rates, and recoveries of petroleum reservoirs. artificial intelligence us government shale reservoir machine learning reserves replacement upstream oil & gas calculation porosity capillary pressure reservoir characterization asset and portfolio management reserves...

... for calculating the forces being applied to remove the rock ahead of the bit. The objective of this paper is to demonstrate a physics-based method to utilize this data to gather a full understanding of the reservoir. Over the past few years, drilling data has been compared against a wide catalog of core measured...

...), gas content, and water saturation calculated by core-log calibration can accurately determine the sweet spot of the reservoir. Logging curve normalization model and shale gas reservoir logging evaluation model based on anisotropy research can effectively guide the identification of sweet spots...

... with the measured ones. gas injection method minimum miscibility pressure enhanced recovery Phase Behavior Upstream Oil & Gas gas drive oil density EOS model oil component CCE test oil-ga system pseudoternary diagram composition psig PVT measurement calculation 4-pc eos model oil-natural...

... were tested in axial compression (zero stress boundary condition) to measure the intact stress-strain behaviour and calculate the intact Young’s Modulus and three vertically printed specimens with zero, one and two specimens were tested in isotropic stress conditions to measure bulk modulus (inverse...