The objective of this study was to perform an integrated analysis to gain insight for optimizing fracturing treatment and gas recovery from Marcellus shale. The analysis involved all the available data from a Marcellus Shale horizontal well which included vertical and lateral well logs, hydraulic fracture treatment design, microseismic, production logging, and production data. A commercial fracturing software was utilized to predict the hydraulic fracture properties based on the available vertical and lateral well logs data, diagnostic fracture injection test (DFIT), fracture stimulation treatment data, and microseismic recordings during the fracturing treatment. The predicted hydraulic fracture properties were then used in a reservoir simulation model developed based on the Marcellus Shale properties to predict the production performance.
In this study, the rock mechanical properties were estimated from the well log data. The minimum horizontal stress, instantaneous shut-in pressure (ISIP), process zone stress (PZS), and leak-off mechanism were determined from DFIT analysis. The stress conditions were then adjusted based on the results of microseismic interpretations. Subsequently, the results of the analyses were used in the fracturing software to predict the hydraulic fracture properties. Marcellus Shale properties and the predicted hydraulic fracture properties were used to develop a reservoir simulation model. Porosity, permeability, and the adsorption characteristics were estimated from the core plugs measurements and the well log data. The image logs were utilized to estimate the distribution of natural fractures (fissures). The relation between the formation permeability and the fracture conductivity and the net stress (geomechanical factors) were obtained from the core plugs measurements and published data. The predicted production performance was then compared against production history.
The analysis of core data, image logs, and DFIT confirmed the presence of natural fractures in the reservoir. The formation properties and in-situ stress conditions were found to influence the hydraulic fracturing geometry. The hydraulic fracture properties are also impacted by stress shadowing and the net stress changes. The production logging tool results could not be directly related to the hydraulic fracture properties or natural fracture distribution. The inclusion of the stress shadowing, microseismic interpretations, and geomechanical factors provided a close agreement between the predicted production performance and the actual production performance of the well under study.