... and injection rates. Therefore, if a sealing fault is located between an injector and a producer, the effect of that fault on production could be easily seen on a connectivity map which is generated from the CM. This research will attempt to use the CM and combine it with the algorithms of fault seal parameters...

..., PROSPER, CMG and Microsoft Excel and consists of eight (8) producers, three (3) gas injectors and six (6) water injectors as outlined in the ExxonMobil Phase 1 development plan. Simulation results indicate that over a twenty-five (25) year period approximately 456 MMSTB of oil and 3.5 TCF of gas...

... selectivization, means like flooding separators, inside the heart of reservoir. In injector wells 3 types of behavior profile logs were ran several times within more than two years. The reservoir under study it is the sand T2 located at Chichimene field, at the Colombia Llanos Basin. It has 320’/250’r of gross...

... there was an opportunity to run the tools. After the identification of water recirculation (Bad Water) in zones with high permeability the immediate action to stop water recirculation and reduce produced water was blocking zones in 1) Producers: Water shut off and/or 2) Injectors. In the long term, a more comprehensive...

... field development with better economic return than water flooding. Moreover, this work shows the importance of applying the process separately for water and polymer flooding, otherwise wrong decisions can be made if simple comparisons are performed. Artificial Intelligence injector enhanced...

... recovery ld27-2 block displacement stage bottom water production well numerical simulation heavy oil reservoir flooding experiment stable displacement stage numerical model SAGD injector Simulation recovery factor steam flooding reservoir Introduction Heavy oil resources are widely...

... (cuboid), which was populated with various layers with properties analogous to a real condensate field to improve the accuracy of the flow path modeling. WINPROP was used to create a detailed fluid model. Using the model as discussed above, the injector placement was varied whilst using a fixed injection...

... of field samples depicted a field plateau rate of at least 100 Mbopd. Development wells, included producers, water injectors and/or gas injectors, are typically in the order of 20-30 for scenarios less than 600 mmbbl. For volumes surpassing this amount, the well count almost doubled. See Figure VI...

... fluid model CMG-GEM. Various scenarios were simulated to determine the optimum number of producers for primary production and the best location of the injectors for CO 2 EOR. The optimum number of producers for the reservoir during primary production was found. In addition, the most favorable location...