... in the later development stage. Laboratory tests on casing material and cementing material have shad lights on possible solutions. Increasing the casing wall thickness and cement thickness seems a viable solution for casing collapse, but the application of these recommendations yielded little effectiveness...

... for several different connection products, i.e., different OD, different wall thickness, and different connection designs (API buttress-type thread, proprietary wedge thread, etc.). Moreover, the model is also able to predict the critical location at which a through-wall crack would develop and cause leak...

... assurance Upstream Oil & Gas inspection incident Talisman Sand Probe Sand Erosion pipeline transient behavior slug catcher Thickness probe trip separator sand separator installation valve Sand Event choke Probe PCV erosion sand trap Introduction Sand separators, also called...

... permeability, bottom water thickness, well penetration and reservoir anisotropy. This study offers a simple analytical model describing the effects of the above parameters on the water-free oil production rate. The model has been derived using principles of the flow potential theory and anisotropy...

... The Bakken Formation ranges in thickness from a maximum of 145 ft (44 m) in western Mountrail County to a feather edge along its depositional limit. The Upper Member is up to 35 ft in thickness. The Middle Member reaches up to 75 ft with a maximum thickness of 85 ft (26 m) in Western Mountrail...

... compressibility Thickness elastic media fracture characterization subsidence rate structural geology pore pressure fluid withdrawal Doroud Field fractured reservoir fluid dynamics investigation spe 107024 society of petroleum engineers hydraulic fracturing fracture distribution additional...

... layer), different scenarios were studied. This study is focused on simulation of formation-A of a carbonate reservoir which consists of three layers; where horizontal well is going to be drilled in layer-2 of this formation. The average thickness of formation-A is about 167.64 meters (550 feet) and we...

..., The effects of the following parameters on productivity have been investigated: well location, pay zone thickness, well producing length, principal permeability, and dimensions of drainage volume. It is concluded that, though each of these parameters has an effect on productivity, the well length...

... inputs included the thickness of the primary source rock (Woodford shale), total organic carbon (TOC), production index (PI), paleo thickness, curvature of paleo structure, and permeability. Two variables were derived; the product of Woodford thickness, TOC and PI, termed generative potential...

... of thickness of the emulsion coating the annular surface. The surface area coated by the emulsion was traced and measured. Downhole emulsion delivery was thus determined by performing the emulsion material balance. The amount of emulsion retained in the system is based on deposited chemical thickness, coated...

... that are available commercially. The current methods do not optimize the thickness of the primer and the mechanisms of corrosion prevention in the presence of abrasive materials are not well understood. This paper addresses these shortcomings of the past and proposes a comprehensive technique for corrosion...

..., no necessary complete experimental data for model were available. Consequently, qualitative results were presented and discussed. thickness crude oil production control mechanism equation mathematical modeling coefficient production monitoring total amount molecular diffusion upstream oil...

... and completion options, hydrocarbon pay zone thickness, well spacing, fracture intensity, vertical communication, formation damage, and multiwell prospect. The total well cost for the horizontal well is divided into two components: the vertical section cost and the horizontal or lateral section cost...

... for the safety of the drilling crew and mechanical integrity of the wellbore. Besides the estimation of these parameters, it will be beneficial to estimate the thickness of the kicking formation prior to drilling. This helps to drill safely and carefully through the potentially active kicking formation...

... at CMR and at Statoil's Research Centre in Trondheim. At CMR the system has been tested for thickness measurement of wax deposit, and at Statoil for the detection of hydrate deposit (and formation). Measurement of wax thickness Abstract Studies of the fluid- and flow properties of reservoir...

... pressure hydraulic fracturing pay thickness compliance net pressure configuration permeability society of petroleum engineers fracturing fluid simulation excess closure stress reduction richardson proppant concentration closure stress conductivity pay interval young percentage pressure...

... Abstract A laboratory experiment has been conducted to study the behavior of water coning under a horizontal wellbore having a stinger inserted. A large Hele-Shaw cell was used to perform the experiment. The length of the stinger employed, oil viscosity, and initial thickness of oil column were...

... of open well, especially if the total open length is distributed among several spaced intervals. This work, using a comprehensive multi- and single-well semi-analytical well performance model, extends the Goode and Wilkinson results examining various open lengths, reservoir thicknesses and permeability...

... threshold value of pressure differential in the wellbore, irrespective of the temperature. chromatograph pressure differential drilling fluid chemistry thickness concentration wellbore filter cake society of petroleum engineers permeability drilling fluids and materials wellbore radius flux...

.... P. 55 hydraulic fracturing thickness upper zone field development optimization and planning fluid dynamics recovery society of petroleum engineers closure asset and portfolio management extension upstream oil & gas completion production log reservoir production period frac...