Abstract
Stable invert emulsion with oil wet solids is achieved using invert emulsifiers and wetting agents. This paper reviews the chemistry and performance criteria of traditional invert emulsifiers and wetting agents utilized in formulating stable invert emulsion drilling fluids. However, occasionally such stable invert emulsion drilling fluids can be destabilized due to various hostile conditions encountered during drilling operation, and can adversely impact the drilling cost. Extreme preventive measures cannot avoid such hostile conditions such as sudden water influx, excessive solids and salt contaminations during drilling. Upon solids becoming extremely water wet with "flipped emulsion", it becomes impossible to fix the drilling fluid, resulting in expensive maneuver. Often situation cannot be corrected with traditional wetting agents and emulsifiers even at high level of treatments.
New innovative chemistry addresses the severe water-wetting and emulsion instability of invert emulsion under extreme challenging and hostile situations. The unique water soluble oil mud conditioner (OMC) synergistically enhances the performances of traditional oil-wetting agents and emulsifiers at very low, as little as 0.5 ppb levels of treatment. This OMC improves and extends the efficacy of the traditional invert emulsifiers and oil wetting agents resulting in reduced usage of these additives with excellent economic advantages.
The 15.0 ppg, invert emulsion drilling fluids were prepared using 2-3 ppb of primary and secondary emulsifiers, and these fluids were destabilized using high shear mixer for 7-8 hours. The destabilized fluids had severe water wet solids and ES value of less than 5. These destabilized fluids, upon treating with 0.5 ppb of newly developed OMC instantly became oil-wet and shiny and ES was increased to greater than 500. To demonstrate the effectiveness of OMC in pre-treatment situation, the base fluids treated with 0.5 −1.0 ppb of OMC showed superior mud stability compared to base fluid when contaminated with sea water, fine solids, barite and high salt contaminations. The OMC is flexible in its application and can be used as pre-treatment to improve the overall performance of drilling fluids and can also be used for post-treatment to recover the drilling fluids, which have been rendered unusable.
