Abstract
The objective of this paper is to depict the quantification of the production rates of the different phases in deviated wells with high gas-liquid relation using the Flow Array Sensing Tool (FAST). The readings of standard Production Logging Tools (fullbore flowmeter, density, and capacitance) are centralized, therefore they are affected if there is re-circulation of the heavy phase (liquid). The phase segregation and possible apparent down flow of the heavy phase makes it very difficult to determine the distribution of the produced fluids, and in some cases the spinner flowmeter tends to stop or gives inaccurate readings. The cause of these inaccurate readings is that the centralized spinner is affected by positive flow in the high side and negative flow in the low side of the wellbore, and the spinner shows no flow or even apparent downhole flow, when there is a real positive flow.
The FAST tool used during the acquisition of the production logs is an ultracompact production logging tool (3 ft long) that is capable to measure multiphase flows with an array of 8 sensors, two in each arm and located 90° apart. These sensors are based on MEMS (Microelectromechanichal Systems), and among the interchangeable sensors we have optical probes that takes ultra-rapid measurements of the refractive index and can determine hold-up of water, oil and gas; the electrical probes that measures conductivity to differentiate hydrocarbons from water, and magnetic probes with micro-spinners to determine the flow rate. Both the three phase optical probes and the electrical probes have excellent response including water hold-ups over 90% that cannot be measured with a standard capacitance tool.
The data logged with FAST in deviated wells was processed and interpreted to obtain the apparent flow velocity profiles of each of the 4 micro-spinners and with the three phase optical probes, and the relative bearing curves the velocity maps, and hold-up maps where obtained. The velocity map showed that there was negative flow in the low side of the well and positive flow in the high side while the hold-up map showed the light phase (gas) in the high side of the well. Both maps showed clearly the flow pattern and were used to quantify the production of each perforation and the total rate matched closely the surface rate (within 2% deviation).
With the hold-up and velocity maps, the real flow rates were obtained with high confidence, and the flow pattern were shown clearly in deviated wells. The three phase optical probes, and electrical probes are excellent indicators of water and hydrocarbons inflow in a wide range of hold-ups.
