Achieving maximum oil recovery utilizing CO2 has limitations when operating at, or very close, to the Minimum Miscibility Pressure (MMP) of the CO2 in the oil. A modular source of CO2 would allow Enhanced Oil Recovery (EOR) flooding of "stranded" and shallow reservoirs. Unfortunately, modular sources of CO2 production often include CO and N2 mixed with the CO2. Thus, testing for EOR application of a mixed gas-containing CO2, N2, and CO was initiated.

Bench scale testing using Rising Bubble Apparatus (RBA), Slim Tubes, and linear core flood have been conducted on oils ranging from 16-42° gravities having viscosities of 0.5-280 cp. All tests were conducted at reservoir temperatures and pressures. CO, being a strong reducing agent, was further tested on reservoir rock containing swelling clays with hydrated ferric hydroxides. Due to the apparent reduction of the ferric hydroxide, and the liberation of its water of hydration, an increase in matrix permeability and clay stabilization, was observed.

For most oils tested, the CO2/CO mixture increased rate of oil recovery by 2-3X, using only 50-60% as much gas/bo as compared to pure CO2. Recovery factors of 80%, at immiscible pressures 30-40% below CO2 MMP, were achieved. Addition of 15% N2 (v/v) to the CO2/CO mixture did not impair oil recovery. Interfacial testing (IFT) of oils, using pure CO, demonstrated a lowering of the IFT. RBA testing of asphaltine-rich heavy oils has shown that a mixture of CO2/CO dissolves into the oil at a far faster rate than either CO2 or CO individually and faster than the sum of both individual gases. A similar test using non-asphaltine type oils did not display this unique characteristic. Slim tube testing suggests that CO facilitates the mobilization of asphaltine-rich heavy oils and lowers viscosity. A linear corefloods of a reservoir containing 5% smectite + illite/smectite + and chlorite demonstrated a 275% increase in matrix permeability. Packed column tests, containing quartz sand and bentonite, demonstrated up to 300-900% increase in permeability in the presence of CO.

Thus a method to recover oil faster, from stranded reservoirs, at pressures below MMP, using significantly less gas, appears possible. In addition the use of CO, either alone or in combination with CO2 and/or N2, has been shown to increase matrix permeability. Such a gas mixture may be beneficial to achieving low pressure EOR from shallow, "stranded" reservoirs, non-conventional shale oil reservoirs, and viscous, heavy oil reservoirs at low temperatures. Incorporation of CO, or CO2/CO, in a frac fluid, or alternately as a post frac cleanup for shale oil and gas applications appears to warrant investigation.

You can access this article if you purchase or spend a download.