The Bakken is among the shale reservoirs which have been discovered to hold a vast amount of oil resource contributing to the production boom in the US. This unconventional reservoir, like most others, displays favorable initial production rates due to stimulation by hydraulic fracturing, but production rates quickly decline after few months. Due to the extremely low permeability and low recovery factors, miscible gas injection is considered for improving the recovery of oil in the Bakken formation. Feasibility of miscible gas injection in the Bakken depends on the analysis of minimum miscibility pressure (MMP) experiments.

The Rising Bubble Apparatus (RBA) has been chosen for the purpose of these experiments. The RBA provides results in a short amount of time using small amounts of fluid samples. The RBA consists of a cell gage containing a flat glass tube where oil samples are placed and an injection needle where gas is injected into the flat glass tube. To simulate reservoir conditions, the glass tube is pressurized using de-ionized water and heating plates surrounding the cell are used to regulate temperature. Visual observation of the injected gas bubble behavior is captured by a camera as it rises and moves upward along the oil column. The MMP occurs when the gas bubble dissolves into the oil before reaching the top of the oil column.

MMP results from a Bakken crude sample show a range from 2340 to 3000 psia at a temperature of 215 °F using CO2 as the injection fluid. Other injection fluids such as nitrogen and hydrocarbon gases have been tested and provided MMP values from 3500 to over 5000 psia depending on the gas. MMP results from Bakken crude oil samples were compared to existing correlations and more correlations were found to produce unreliable MMP results. Further comparison using an equation of state phase-behavior program has shown similar results with the RBA MMP results.

The impact of different injection fluids, inclusive of CO2 and enriched hydrocarbon gases is the subject of this study. MMP results are influenced by the choice of injection fluids, providing valuable information for economic production and increased recovery in the Bakken formation. The results from this study provide MMP data for a range of injection fluids that can be used in planning pilot tests for miscible gas injection in the Bakken.

You can access this article if you purchase or spend a download.