1-20 of 79
Keywords: operation
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199247-MS
... challenge in cold operations, while sand control is the main challenge in thermal operations. Tectonic history is more critical in comparison to the similar cases in North America. The complicated tectonic history, necessitates the geomechanical models to strategize the sand control especially in cased and...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199263-MS
... Abstract Formation damage can significantly defer hydrocarbon production. Formation damage is one of the key parameters to evaluate the quality of various operations during the life of a well. The evolution of formation damage over the long run is rarely studied. This paper will present a new...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199239-MS
... modeling of SAS in thermal operation. It also provides an insight into the fluid flow, fines migration, clogging and bridging in the vicinity of sand screens. sand control sand pack sand/solids control heavy oil technical conference experiment Mahmoudi Screen Selection Exhibition SRT...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199283-MS
... Hydrate Remediation hydrate inhibition asphaltene inhibition inhibitor operation conductivity substrate flow assurance slow release asphaltene additive protection loading delay mechanism fracturing fluid manual oil analysis asphaltene deposition sraa release asphaltene additive proppant...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199319-MS
...-off was observed during main acid treatment due to the tight nature of the formation that resulted in low fluid efficiency and relatively short etched fracture length. Acid fracturing treatment was carried out successfully without encountering any major operational issues. The post-acid frac...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199251-MS
... improve future completions. Upstream Oil & Gas Case History workflow erosion dimensionless time pack treatment gravel pack friction pressure sand/solids control carrier fluid open hole Bridge fluid failure shunt washout sand control completion operation packer incomplete pack...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199321-MS
... & Gas selection acidizing operation Simulation information formation damage reagent structural geology formation damage removal technology Sandstone Reservoir composition comprehensive approach society of petroleum engineers interaction reservoir simulation software formation damage...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199277-MS
... Abstract Controlling lost circulation during drilling operations in a reservoir prone to losses is typically remedied by cement squeezing or plug setting. The aim being to minimize or stop drilling fluid losses and to regain full returns at surface, and to affect wellbore integrity. Different...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199298-MS
... Abstract Advances in horizontal drilling and completion techniques have proliferated onshore development of unconventional shale fields. These wells can span hundreds of miles across a field for a single operator. Live remote monitoring and automation of operations is ideal but rarely cost...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199238-MS
... Abstract Objectives/Scope: The paper is a case study of the impact of acidizing in a carbonate formation. The paper shares the operator’s observations and the approach taken to investigate the matter. The operator’s success in improving the acidizing approach is also discussed in detail. The...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199305-MS
... typical MWD pulser due to the narrow geometries of the flow paths within. Successful onshore testing was conducted prior to drilling operations to prove that the MWD pulser selected had the ability to permit the flow of ultra-high concentrations of LCM. A closed loop system was created onshore and LCM...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199291-MS
... Abstract Hydrochloric acid (HCl) is the acid of choice for acidizing operations in most carbonate formations and is the base acid commonly paired with others such as hydrofluoric (HF) in most sandstone applications. However, high dissolving power, high corrosion rate, lack of penetration, and...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199295-MS
... common challenge during waste slurry injection (WSI) is the continuous loss of well injectivity due to poor engineering design of the injection parameters for most of the current existing WSI wells. For the WSI operation, near wellbore formation damage (including the fracture damage) will be formed by...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 19–21, 2020
Paper Number: SPE-199331-MS
... fluid producing the water hammer and shockwave effects. Operationally the multi-directional, cavitation-based fluid pulsing tool has two operating modes: extended and retrieved ( Figure 5 ). In the extended mode the tubulars and wellbore are subject to 3600 of fluid flow through twelve fluid...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 7–9, 2018
Paper Number: SPE-189467-MS
... measured again after cutting operation and the results are presented in Table.2 . As observed, both porosity and permeability values of core samples were increased compared to original values as expected, except the porosity of Core #3. De-ionized water and n-decane were used in this study as displacing...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 7–9, 2018
Paper Number: SPE-189538-MS
... package. However, once the operation was restarted the acid was successfully bullheaded into the formation and no issues resulted with the low carbon and CRA based metallurgy of the completion even after this extensive unplanned exposure. Additionally the treatment resulted in a significant productivity...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 7–9, 2018
Paper Number: SPE-189494-MS
.... Upstream Oil & Gas Drillstem Testing fault structure azari optimization problem pressure data Artificial Intelligence drillstem/well testing well production operation drainage area society of petroleum engineers flow rate enhance well production rapid pressure decline Hassi Messaoud...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 7–9, 2018
Paper Number: SPE-189539-MS
... different screen type screen type comparative study flow rate Alberta operation aperture size coupon completion Mahmoudi integrity OFA Sand production from petroleum wells takes place if the hydrodynamic forces on the sand particles exceed the inter-particle resisting forces. Sanding can...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 7–9, 2018
Paper Number: SPE-189516-MS
... rotary jetting test using clean fluid. In order to avoid any possible formation damage during operations, RD job procedures have been optimized by using the different fluids mixtures during jetting, backwash and enlarging the created lateral holes. Jetting fluid used was brine mixed with NH 4 CL and...
Proceedings Papers

Paper presented at the SPE International Conference and Exhibition on Formation Damage Control, February 7–9, 2018
Paper Number: SPE-189550-MS
... experienced for the well No. 4 compared with previous reservoir sections, and there was no indication of poor hole cleaning during drilling, tripping, or during lower completion operations, and no stuck-pipe incidents were experienced. In the previous reservoir sections, a stuck-pipe incident had been...

Product(s) added to cart

Close Modal