The most common stimulation technique of shale gas production is multistage hydraulic fracturing. However, the implementation of the technique brings in new formation damage considerations. Large quantities of water-based fracture fluids, over 75% of the injected volume, usually left unrecovered at the start of production that leads to permeability reduction and low productivity. Accidently, some operators found an improvement in gas recovery after shut in the wells after flowback due to pipeline restriction. They called this behavior as the soaking effect.

This study presents a workflow to evaluate the effect of the soaking process on the well performance after the hydraulic fracturing process in actual field cases. Waterflow back analysis was conducted for 21 well to estimate the effective fracture volume before and after the soaking process. Rate transient analysis (RTA) was conducted on the production data to estimate the stimulated reservoir volume (SRV) in each well. SRV and the enhanced recovery were correlated to the soaking time. Decline curve analysis for water and gas flow rates were conducted to estimate the estimated ultimate gas and water recovery (EURg, and EURw) before and after the soaking process.

An increase in the gas flow rate was observed with soaking time with low water production. SRV increased with the soaking process up to 53% of its initial value with shut-in the well for 180 days. EURw decreased by 52 % of its value before the soaking process, while EURg increased by 48%. Shut-in the well before gas-kick off after hydraulic fracturing operations negatively impact the well performance and the gas production can decrease by 22% even after soaking process for 315 days.

This study will present a methodology to evaluate the soaking process, and recommendations to improve the impact of the soaking process on well performance.

You can access this article if you purchase or spend a download.