Abstract
North Sea lithologies are often complex creating a difficult environment to deliver effective zonal isolation with standard cementing practices. With ever-present weak, fractured, and unconsolidated formations, the practice of fully lifting heavier cement up the annular gap between the formation and the casing or liner often times compromises the formation and the cement integrity. Wellbore Stabilizing (WBS) technology has been shown capable of providing zonal isolation under these difficult conditions.
A cementing spacer has been developed that incorporates WBS technology providing a simple way to deliver the technology in front of any cement job, without compromising the cement integrity or requiring any last-minute slurry design or redesign. By separating the placement of the WBS technology from the cement itself, the cement slurry can be designed with the sole focus being on the interval's zonal isolation requirements.
On Askepott wells in the Norwegian part of the North Sea, the Nordland weak zone is encountered after drilling out the 30-inch shoe from the Oseberg Vest H template. Cement back to the seafloor is required when cementing the 20-in casing in these 26-in. holes. Prior to the introduction of the WBS technology, pressure had been observed on the D-annulus, hinting at a lack of sufficient cement circulation. With assistance from this new WBS spacer, pressure is no longer observed in the D-annulus indicating the cement is now being circulated back inside of the conductor string. The WBS spacer has also been used successfully ahead of cement across the production interval in wells where losses were typically expected, and again full returns were observed.
Normally cement spacers are utilized to separate the drilling fluid from the cement as these two fluids are normally incompatible with each other and to help push the drilling fluid out of the well so the annulus may be completely filled with cement. If the drilling fluid is not successfully displaced from the annular space, the zonal isolation intended by the primary cement job is usually less than ideal. In addition to these standard functions in preparation for cementing operations, this specialized WBS spacer also can prevent loss of cement to the formation.
