1-12 of 12
Keywords: temperature distribution
Close
Sort by
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199946-MS
... completion. Numerical simulations show that the use of a low-loss zone around the central emitter leads to a very much improved energy and temperature distribution, and higher penetrations (~12 m) than the case without it. drilling fluids and materials resin enhanced recovery upstream oil & gas...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199916-MS
... enhanced recovery steam-solvent combination flow in porous media oil sand bitumen steam-assisted gravity drainage reservoir simulation pore-scale simulator temperature distribution viscosity simulator complex reservoir fluid dynamics mass transfer production control reservoir surveillance...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199954-MS
... been developed for predicting ISR performance and shared publicly. The developed model has been validated using numerical simulation data and is capable of properly predicting a temperature distribution in a steam-solvent gaseous chamber in the presence of a fixed source of heat in an injector...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189714-MS
... production control bitumen Upstream Oil & Gas MHz convection recovery rf-thermal recovery higher frequency critical consideration antenna temperature distribution heavy oil recovery Lambert society of petroleum engineers approximation electromagnetic heating application far-field...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189719-MS
... and mass transfer of multicomponent solvents–steam–heavy oil system at the interface. steam-solvent combination temperature distribution enhanced recovery Upstream Oil & Gas mass transfer transition interface thermal method steam-assisted gravity drainage Proportion transitional...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189764-MS
... oil reservoir numerical simulation RF heating base case temperature distribution heating concave antenna convex design temperature profile Introduction The use of electromagnetic radiation in the radiofrequency region (1 kHz to 100 MHz) for dielectric heating has potential applications...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 10–12, 2014
Paper Number: SPE-170164-MS
... oil pay zone cSOR case 14 steam chamber well pattern SAGD process Modeling & Simulation reservoir injector temperature distribution case 3 injection permeability Introduction The production potential of heavy oil in oil sands reservoirs in Alberta is greatly high. The original...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 11–13, 2013
Paper Number: SPE-165393-MS
... anisotropic behaviours. In this research, dilation strains are assumed to be negative. Based on the hypothesis of homogenization, the thermally induced strain in shale can be expressed as: SAGD temperature distribution stern layer enhanced recovery thermally particle thermal method steam-assisted...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 11–13, 2013
Paper Number: SPE-165415-MS
... conservation equation flow model fluid flow equation heat capacity periodical electric heating electrical cable production time temperature profile society of petroleum engineers temperature distribution Introduction (2) ∂ ∂ t [ h g ρ g ] + ∂ ∂ Z [ h g...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-158258-MS
.... Therefore, the goal is to determine the evolution of temperature distribution during the non-injection period in order to have the final temperature distribution at the end of this period when air injection is resumed; this would allow assessing if the easy resumption of the ISC process is feasible...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157800-MS
... before, the condensation model also assumes a circular hot-zone shape since in the early stage of SAGD operation, and characterize the system as composed of a steam-zone of steam temperature, a cold-zone of reservoir temperature and a transition-zone in between as the initial temperature distribution...

Product(s) added to cart

Close Modal