1-18 of 18
Keywords: strength
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189749-MS
... increased by more than a factor of two. The heating reduced the viscosity of the heavy oil in the pack, causing the apparent strength of the sand to decrease. Pressurizing the sand pack with methane and then slowly depressurizing it did not destabilize the wormhole. However, pressurizing the pack...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189751-MS
... to avoid a potential caprock failure during thermal projects, as unfortunately was experienced in the Joslyn SAGD steam release incident. enhanced recovery reservoir geomechanics steam-assisted gravity drainage strength Upstream Oil & Gas caprock thermal method SAGD ground surface...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, February 15–16, 2017
Paper Number: SPE-184965-MS
... system exhibits stable mechanical properties for a long duration during the whole process of the heavy oil production and can be mixed and pumped with conventional cementing equipment. It is placed at low (110-140°F) temperature, acquires sufficient compressive and tensile strength to withstand...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, June 7–9, 2016
Paper Number: SPE-180746-MS
... in thermal stimulation process( AGAR, MORGENSTERN et al., 1983 ; BUTLER, 1986 ) which might result in pore pressure increase and anisotropic stress status. To which extent this factor might affect the strength of IBS depended on the competition between thermal expansion and pressure dissipation...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, June 9–11, 2015
Paper Number: SPE-174403-MS
... drainage strength Reservoir Characterization SAGD Upstream Oil & Gas requirement practical approach sediment AER thermal expansion expansion permeability water hammer condensation fracture operation steam release Carlson reservoir simulation society of petroleum engineers...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, June 9–11, 2015
Paper Number: SPE-174466-MS
... of wormhole networks, and the depletion regions. Consequently, they provide predictive value for developing CSI operation strategies for successful post-CHOPS CSI applications. enhanced recovery strength CSI well cold heavy oil production porosity pressure gradient Upstream Oil & Gas...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, June 9–11, 2015
Paper Number: SPE-174493-MS
... within the wellbore, and using pre-flushes to aid mud cleaning. Thermal cements, suitable to avoid strength retrogression at elevated temperatures, are required for thermal applications. SAGD reservoirs are typically shallow and initial formation temperatures range between 5°C and 15°C. Furthermore...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, June 9–11, 2015
Paper Number: SPE-174483-MS
... the casing cement under extreme stresses due to the rapid temperature increases that occur during initial steam stimulation. The prevailing mentality in the industry for many years was that compressive strength alone was a satisfactory predicator of a cement's ability to withstand downhole stresses. However...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 10–12, 2014
Paper Number: SPE-170016-MS
... strength. More than nine wells have been cemented with this system in Colombia with good results. These wells have been subjected to different stresses (production, steam injection, and ISC). This paper presents the successful application of advanced non-Portland cement slurry within the Quifa heavy oil...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 10–12, 2014
Paper Number: SPE-170048-MS
... integrity injection strength operation operator well integrity cement formulation cement chemistry steam injection mechanical property novel steam-resilient cement system steam-resilient cement system society of petroleum engineers cement sheath Introduction A heavy oil field...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 10–12, 2014
Paper Number: SPE-170132-MS
... Abstract This paper describes a numerical investigation of hydraulic fracturing in oil sands during cold water injection. Previous studies have shown that hydraulic fracturing in unconsolidated or weakly consolidated sandstone reservoirs is highly influenced by the low shear strength...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 11–13, 2013
Paper Number: SPE-165392-MS
..., Canada. Density and sonic logs were applied to estimate the dynamic deformation modulus, Poisson's ratio, internal frictional angle, and cohesion strength. Gamma ray log is applied to estimate shale's clay content. Triaxial tests and confined torsion tests were conducted on samples to investigate...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 11–13, 2013
Paper Number: SPE-165493-MS
.... To demonstrate the use of the proposed analysis approaches and considerations, an example case with a generic premium connection geometry is analyzed and the results are presented. SAGD strength casing design Upstream Oil & Gas specimen configuration thermal method steam-assisted gravity drainage...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157811-MS
... management pipeline corrosion production chemistry upstream oil & gas stainless steel cscc spe 157811 chloride stress corrosion super duplex stainless steel alloy flowline corrosion oilfield chemistry riser corrosion strength duplex stainless steel corrosion resistance concentrator...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157892-MS
... occur, impacting the cement matrix and hence changing its properties. This paper describes the application of a new thermally responsive cement for zonal isolation of heavy oil wells in Canada. This system is designed to have excellent strength, flexibility and thermal properties even upon interaction...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157912-MS
... confiningpressure permeability injection scenario reservoir geomechanics strength porosity integrity mem Introduction This paper presents a case of integrated geomechanics workflow involving geology, petrophysics, reservoir engineering with geomechanics to evaluate integrity of the Wabiskaw caprock...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157921-MS
.... casing and cementing blend 3 cement blend critical interval cement chemistry isolation free water operation cement formulation spe 157921 wellbore temperature cement system temperature range slurry sagd well blend 1 wellbore cement property gel strength upstream oil & gas strength...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157869-MS
... by the flow to the wellbore, and then to clogging of the screen holes or penetration into the wellbore. Definition of ultimate tensile strength and its comparison with actual tensions on wellbore wall Abstract This article describes the results of a theoretical and numerical study of the problem...

Product(s) added to cart

Close Modal