1-9 of 9
Keywords: oil sample
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199936-MS
... the bitumen properties. This paper focuses on the compositional changes observed on Athabasca bitumen during air injection after SAGD in a 3-D large scale experiment. Changes in bitumen properties, as measured from produced and residual oil samples, such as density, viscosity, asphaltenes content...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189752-MS
... The physical interactions between steam and oil samples were investigated in the presence and absence of surfactants. A Bransonic-220 ultrasonic water tub was used to mimic micro-emulsion formation during steam-surfactant flooding. An equal mass oil-surfactant solution mixtures (four grams) were...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189727-MS
... Phase Behavior fraction live oil sample SCN fraction Modeling & Simulation characterization scheme experiment mass fraction Upstream Oil & Gas oil sample workflow heavy oil critical property oil characterization asphaltene SARA fraction splitting molecular weight...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, February 15–16, 2017
Paper Number: SPE-185008-MS
... less attractive. Recent experiments using conventional oil samples showed that the incorporation of silica nanoparticles in the injected solution (i.e. nanofluid) can dramatically enhance oil production. Nanofluids are more stable than polymers in harsh reservoir conditions, also they can modify...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, June 9–11, 2015
Paper Number: SPE-174465-MS
... Abstract A representative clean heavy oil sample (<1% BS&W) is crucial to obtain accurate fluid property data, which are required for heavy oil production, processing, and transportation designs. However, it is always a challenge to remove water from a heavy oil sample (<20° API) due...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference-Canada, June 11–13, 2013
Paper Number: SPE-165444-MS
... process for the heavy oil recovery which requires low facility investment. enhanced recovery waterflooding bitumen Modeling & Simulation propane viscosity recovery slug size hot water sand pack Injection Rate oil sand complex reservoir methane oil sample heavy oil Oil Recovery...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-157835-MS
... of the live heavy crude oil sample was introduced into the cell to form a thin live heavy oil layer on the left-hand side window by using the programmable syringe pump. The incident light intensity of the light source, magnification and focus of the microscope camera were properly adjusted and set in order...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-146107-MS
... viscosity heterogeneity in addition to rock heterogeneity. complex reservoir heterogeneity bitumen heavy oil weight saturate vsara fraction heavy oil sample laboratory oil sand resin viscosity experiment heavy oil fraction sara fraction asphaltene fraction operator upstream oil...
Proceedings Papers

Paper presented at the SPE Heavy Oil Conference Canada, June 12–14, 2012
Paper Number: SPE-158341-MS
... f, g, h: the mixture of ligarine and toluene The oil samples are heavy oil, extra-heavy oil, and bitumen. The solvents used in the experiments are ligarine, toluene and diesel. And there are three kinds of ligarine used as solvent in the experiments; they are ligarine with boiling point...

Product(s) added to cart

Close Modal