1-20 of 124
Keywords: experiment
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199950-MS
.... Fig. 2 shows the concept of this experiment. Figure 2 Graphical illustration of the experimental concept The amounts of precipitated asphaltene in the PVT cell were calculated from recurrence relations by use of the analyzed asphaltene weight fraction in supernatant fluid, measured...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199942-MS
... upstream oil & gas point pressure reservoir surveillance bubble point pressure pressure depletion rate live oil sample nonequilibrium condition experiment depletion rate expansion rate experimentally pvt cell university oil system rebound pressure supersaturation pressure ccec test...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199959-MS
.../DSC are given in Table 2 . Table 2 Nomenclature for the Reaction Kinetics Experiments to Investigate the Role of Carbonates on Combustion at 15 °C/min Heating Rate The experimental samples underwent oxidation by continuous air injection (50 ml/min) at a constant heating rate...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199948-MS
... 2 + 10.93 α 3 − 6.33 α 4 + 1.42 α 5 The DNV erosion model ( Det Norske Veritas, 2007 ) was developed based on experimental results available in the literature and the experiments conducted by Det Norske Veritas. Most of the data used in developing the correlation belong...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199960-MS
... per square feet of the screen (lb/sq.ft.), which exceeds the acceptable threshold of 0.12 to 0.15 lb/sq.ft. for typical SRTs. Based on the pressure drops and produced sand results, a 0.010″ aperture size was recommended for the target formation. This paper outlines the results of the experiments...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199915-MS
... the cumulative oil recovery results from 100. The recovery mechanism in each experiment was further investigated by produced oil characterization in terms of asphaltenes content and water content in water-in-oil emulsion form ( Table 3 ). Table 3 Summary of the experimental results on asphaltenes...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199961-MS
... throughout the constant-pressure diffusion experiment. The experimental setup was then used for studying the concentration-dependent behavior of the diffusivity of gaseous dimethyl ether (DME) in bitumen at 2.76 MPa and 110°C. The estimated values of the molecular diffusion coefficient are in the range...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199966-MS
... is presented in Table 1 . Before starting the experiment, oil was filtered to remove any excess water. Table 1 SARA Fractions by ASTM method. A considerable amount of oil reserve will be left in place by the end of thermal treatment. As the temperature of the reservoir drops, most...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199925-MS
.... Thickness of the vapor zone, on the other hand, should be also minimized since this zone is too hot for any additive/steam condensation to occur. The laboratory experiments presented in this work were obtained once the condensing conditions in the vessel were optimized through multiple experimental...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199934-MS
... rounds separately using the experimental setup simplified in Fig. 4 . Two one-dimensional sand-packed models were employed in this section and the physical properties of the model were shown in Table 2 . In the experiments, oven temperature kept constant 150°C. Steam injection rate was 10ml/min and CO...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199922-MS
... ratio caused by the experimental flow rates. It is observed that the relative permeabilities to gas are very similar at the residual liquid saturations achieved in the experiments ( Table 3 ). Due to the relative high residual oil saturations achieved in the experiments, the obtained gas relative...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Conference, September 28–October 2, 2020
Paper Number: SPE-199936-MS
... temperature combustion front when injecting air into a steam chamber has been recently demonstrated with a three-dimensional (3-D) large scale experiment. In order to effectively mobilize bitumen, bond scission reactions are required to occur between the injected oxygen and the bitumen. The highly effective...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189745-MS
... mitigation strategy. In Figure 9 are presented the oil production results in terms of fraction of OOIP during the different stages of Exp. 2.1 and Exp. 2.2. Experimental procedures are the same for these two experiments except that the initial oil saturation is not achieved by the same method for Exp...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189749-MS
... in these experiments was relatively low, the experimental cell did not allow for stress redistribution due to the deformation of the sand matrix, as would occur in the field. For this reason, the wormholes generated in the experiments were less stable than ones in the field. Consequently, the laboratory conditions...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189715-MS
... the results of Butler models, Reis, and this work to the experimental data of Butler, McNab, and Lo (1981) . The rock and fluid data used in their experiment is shown in Table 1 . Figure 5 Oil production rate comparison by the use of data from Butler, McNab, and Lo (1981) . Table 1...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189754-MS
... in Figure 6 , the model under-predicts the oil production rates by 25-35%. Figure 6 The estimated oil production rate of VAPEX experiments versus the reported experimental values by Yazdani and Maini (2005 , 2006 ); open squares are predicted using dispersivity of Model-C#3 with 12-16 glass beads...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189727-MS
... of SARA fractions (saturates, aromatics, resins and asphaltenes), which is aligned with the reaction modelling approach used in most kinetic models. The methodology requires conventional oil characterization (i.e. based on distillation cuts) and conventional phase behavior experiments (e.g. differential...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189757-MS
... thermal method Upstream Oil & Gas injection well production well west side oxygen injection combustion enriched air injection SAGD experiment operation injection combustion front steam-assisted gravity drainage bitumen saturation reservoir society of petroleum engineers One...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, March 13–14, 2018
Paper Number: SPE-189734-MS
... This paper presents the results of an experimental investigation on the influence of anisotropic (unequal) horizontal principal stresses on the direction of wormhole growthin a sand pack saturated with viscous oil. Two sets of experiments were performed – one set in which the sand pack...
Proceedings Papers

Paper presented at the SPE Canada Heavy Oil Technical Conference, February 15–16, 2017
Paper Number: SPE-185017-MS
... parameters, a e , β 1 , and β 2 , the simulations were able to history match all the experimental data. The last 3 columns of Table 2 record the history matched model parameters. Table 2 Experiments with different oil viscosities, rates and core diameters, and summary of history-matched model...

Product(s) added to cart

Close Modal