1-20 of 251
Keywords: gas injection
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 3–5, 2022
Paper Number: SPE-210140-MS
... qualification testing. Scavenger Performance corrosion management gas injection reservoir surveillance h2s management production chemistry enhanced recovery artificial lift system gas lift upstream oil & gas application ci si phase pad spe international conference production control...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206102-MS
... of the application show that the proposed approach can optimally allocate the shared resources. production control artificial lift system artificial intelligence gas injection cost function difference reservoir surveillance gas lift subsystem upstream oil & gas controller mass flow rate...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206182-MS
... based on reservoir response, and units can be installed deeper into the deviated section of the well without any deviation limits. In-Situ gas lift is a specific application where a gas zone is used to lift production from the oil zone in the same well. DIAL enables measurement of the gas injection...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206190-MS
..., and not be produced. This is considered as a great money loss. ( Amini, 2011 ) OBJECTIVE Gas injection is one of the most effective solutions to prevent condensate blockage, along with horizontal drilling, reservoir stimulation and wettability alteration. The main principle of gas injection to retrograde gas...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206262-MS
... the surface, with a large spectrum of gas injection rates. The operator can vary the gas injection rate by opening or closing valves, in any combination, which can each have a different port size, giving the operator a huge range of possible injection rates. The DIAL system is not dependent on casing pressure...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206213-MS
... optimization and sensitivity analysis on key parameters for best gas lift performance. gas injection capital efficiency artificial intelligence upstream oil & gas performance curve operation historical performance artificial lift system gas lift augmented ai approach statistics qq field...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-208633-STU
... to predict what the most optimal type of plungers is for a given well in order to reduce gas injection and maximize liquid production. To accomplish this project, more than two million rows of raw plunger lift production data were queried using SQL, a database query language, then pivoted, cleaned...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-205962-MS
... devices (ALD's), a method called Backsweep (Patent application 17095440) was proposed by Croce and Zerpa (2021) . The method relies on intermittent gas injection to remove the stagnant liquid from the horizontal section, clearing the way for the gas incoming from the reservoir to flow to the wellhead...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206198-MS
... made it possible to have a closer look in multiphase flow phenomena as the function of time and to answer the questions. Introduction gas lift computational fluid dynamic fall back gas injection inclination angle productivity index pipe flow regime artificial intelligence fluid...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, September 21–23, 2021
Paper Number: SPE-206117-MS
... Abstract The application of non-hydrocarbon gas injection for enhanced gas and condensate recovery (EGCR) is still in a developmental stage as the mixing/interaction between the injected gas and resident reservoir fluid is yet to be extensively understood and the inability to optimize...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201603-MS
.... artificial lift system chemical flooding methods downhole intervention drilling fluid management & disposal gas injection enhanced recovery drilling fluids and materials intervención de pozos petroleros gas well deliquification well intervention upstream oil & gas ppm pvt measurement...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201585-MS
... is heavily relied upon, its efficiency is typically low and varies widely depending on well depth and amount of gas injection required ( Clegg et al. 1993 ). Therefore, improving and standardizing the efficiency of gas lift operations is expected to cut capital expenditures and solidify the competitive edge...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201648-MS
... to reduce lift gas consumption, while maintaining or even increasing the original oil production. intervención de pozos petroleros artificial lift system production monitoring enhanced recovery reservoir surveillance drilling fluids and materials drillstem testing gas injection method downhole...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201435-MS
... offloaded at around 900 bbl. of gross fluid using JP technology. production control hydraulic jet pump drillstem testing production monitoring jet pump reservoir surveillance completion installation and operations upstream oil & gas artificial lift system multiphase pump gas injection...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201403-MS
... Abstract The purpose of this paper is to highlight the results of a comprehensive investigative study that quantifies the multiphase flow-related differences in multiphase hydrostatic pressure gradient, oil holdup and gas velocities as the gas injection depth is lowered from vertical to higher...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201255-MS
... not properly addressed within the industry. This work’s proposed intelligent gas lift scheme can be a potentially valuable solution to unstable unloading of liquids, and benefit the operators significantly in production and revenues. gas lift compressor intelligent gas lift compressor gas injection...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201298-MS
... required to construct, calibrate, and optimize around 50 wells was less than two weeks. machine learning reservoir characterization production control artificial lift system enhanced recovery asset and portfolio management gas injection method upstream oil & gas category workflow well...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201471-MS
... Enhanced oil recovery (EOR) using gas injection, such as carbon dioxide (CO 2 ) or hydrocarbon (HC) gases, has been widely studied. Recently, produced HC gas (primarily methane, ethane, and propane) has been employed in numerous pilots in several unconventional plays. Successful applications...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201509-MS
... and practical method for predicting instability onset conditions and developing mitigation strategies in existing and new-built production facilities. artificial lift system production control flowline corrosion materials and corrosion reservoir surveillance gas injection slug catcher completion...
Proceedings Papers

Paper presented at the SPE Annual Technical Conference and Exhibition, October 26–29, 2020
Paper Number: SPE-201522-MS
... was successfully eliminated and production from the platform was partially recovered. enhanced recovery upstream oil & gas separation and treating drillstem testing gas injection drillstem/well testing instrument gas scrubber instrumentation system gas lift pipeline air compressor pipeline...

Product(s) added to cart

Close Modal