... resistance to forward motion. As part of the planning process for future longer wells, predictive torque and drag analysis was used to compare various equipment configurations and running scenarios, and to provide an indication of the torque demand relative to casing connection limitations. This also...

... decompression experiment gor upstream oil & gas decompression experiment amplitude drillstem/well testing equation of state compressibility module detection annual logging symposium heterogenous nucleation configuration application sensor paper Introduction Formation testing has...

... Abstract A closed-loop geothermal well design is presented which incorporates both wellbore configuration and completions components as well as a strategy for well operations which together achieve meaningful production of thermal energy. Planning and optimization of intermittent circulation...

... will be further discussed in this study. A similar study ( Duan et al. 2008 ) conducted with highly deviated configurations examined the effect of rotation. A flow loop of 100-ft long with an annular test section of 8ʺ × 4.5ʺ was used in the study. Experiments were conducted with three different cutting sizes...

... systems and equipment provider drilling equipment reliability compliance bha reliability configuration challenging standard practice improvement vibration application standard practice resulted metric downlink Standard Practices & Metrics Repeatable well delivery requires standard...

... of sound (SoS) and, depending on the type of application and how the system is installed/configured, it may also measure flow velocity. In its current state, the DAS technology is still not fully explored in multiphase flow measurement for reasons including but not limited to the lack of flow algorithms...

... separation and treating enhanced recovery upstream oil & gas reservoir pressure conclusion pipe separator injection configuration separation water cut petroleum engineer horizontal well Introduction Downhole oil water separation (DOWS) has been subject to discussion and evaluations...

... presented segmented cone spe annual technical conference log analysis drill pipe selection openhole clad diameter restriction expansion assembly drift diameter installation configuration release joint drilling operation cone inch drift drift monodiameter completion system wellbore...

... motor. The mud positive displacement motor with various lobe configurations and designs becomes an additional excitation source of vibration. Further, it affects the transient behavior of the performance mud motor. Unbalanced force exists because the center ofmass of the motor rotor does not coincide...

... configuration water specific mass mpa wellbore integrity cement chemistry pore pressure experiment cement hydration reservoir geomechanics complex reservoir upstream oil & gas rock mechanics geomechanics symposium cement sheath exhibition cement system consequence high temperature...

... to recover the permanent shape of LCMs, which could expand ten times larger than the temporary (programmed) dimensions for deployment. Smart LCMs are a combination of various material categories such as granular, fibrous (one-dimensional or 1-D) and planar (two-dimensional or 2-D) configurations that resume...

.... The main objective was to optimize impeller vanes geometry to reduce friction losses in the boundary layer (layer of a flowing liquid in contact with a surface), and to verify the performance of different configurations. The design process of the new stage considered the following 5 phases: Phase 1...

... back into the PSS equation to calculate shape factors for that reservoir geometry.We used shape factors previously presented by other authors for square drainage areas to validate themethod before applying it to calculate shape factors for more general drainage area configurations. We present shape...

...Background Enhanced hydrocarbon recovery/IOR/EOR methods combined with multistage hydraulic fracturing can be categorized as longitudinal or transverse configurations based on the orientation of the hydraulic fractures to the wellbore as shown in Fig. 3 . Longitudinal Configuration...

... that's below expectations where HFTO is not able to be explicitly measured. frequency configuration 1 vibration level shear length upstream oil & gas backrake bha torsional vibration secondary cutter rpm bit selection resonant frequency hfto amplitude configuration shear area...

... and quantified in terms of changes in wettability and pore-scale fluid configuration, while also measuring the overall effect on recovery. The results were compared to the behavior under high salinity waterflooding (HSW). To achieve the wetting state found in oil reservoirs, an Estaillades limestone core sample...

... wolfcamp bit selection upstream oil & gas variation rop rotation presentation bit rpm assembly torque configuration directional drilling systems and equipment lateral real-time measurement bha mse adj rpm society of petroleum engineers Introduction A series of DBR bit dulls...

... Abstract This paper investigates the effect of variable perforation configurations on proppant transport, settling, and distribution across different perforation clusters in multistage horizontal wells. The results are compared to other previously published data ( Ahmad and Miskimins, 2019...

... oil & gas formation dip inversion logging while drilling well 3 plane configuration symposium directional resistivity lwd resistivity apparent resistivity lwd well 1 deep directional resistivity lwd deep directional resistivity lwd measurement anisotropy Introduction...

... for the optimization parameters of IDLHC to the IDLHC–ML and, then, we compared the NPV and the number of simulation runs considering different configurations of IDLHC parameters. In this paper, we evaluated a total of twelve ML regression techniques, such as Bayesian Ridge, Random Forest, and stacked ensemble...