... model to convert subsurface pressure variations into surface deformation, optimization methods were employed to invert the surface deformation data and derive the pressure distribution within the reservoir. The model's proficiency was demonstrated by utilizing synthetic deformations generated...

... respectively, dimensionless. In Equation 8 , the overall heat transfer coefficients can refer to Hasan-Kabir model ( Hasan and Kabir, 1994 ; Hasan et al., 2010 ). Hydrate reformation region prediction Based on the calculation of temperature and pressure distribution in gas hydrate production well...

... prediction commercial simulator pod basis function fluid dynamics gas reservoir nirom saturation distribution reservoir model artificial intelligence upstream oil & gas report step pressure distribution training parameter nirom simulation INTRODUCTION Reservoir simulation plays...

... is obtained. Second, the formation pressure distributions and the average formation pressures within the SRV area are calculated. Then, a virtual equivalent time is proposed by use of the average formation pressure. Thus, the production data with abrupt changes can be converted into several interconnected...

... for the case of arbitrary pressure distribution developed as a result of flow of non-Newtonian fluid through the proppant pack has been discussed in the literature. In this paper, the work has been further extended to include the effect of fluid leakoff through fracture faces for radial fractures...

... interpretation porosity model pressure distribution reservoir model reservoir flow capacity triple porosity model drillstem testing storage capacity vug pressure drop ooip dual porosity carbonate reservoir permeability matrix pressure response fracture drillstem/well testing Introduction...

... was caused by the casing-cement tunnel. control method evaluation ariffin samsuri modeling & simulation artificial intelligence perforation pore pressure distribution upstream oil & gas pressure drop university casing-cement tunnel perforation roof pressure distribution reservoir...

... on a near-wellbore approximation of the pressure distribution during pseudosteady-state. Well performance calculated in the well model is correlated to the conditions in the appropriate location from the actual well. This approximation overcomes an inaccuracy for fluid flow calculation in the vicinity...

...Grid Generation Method reservoir simulation grid system water saturation distribution modeling & simulation anisotropic ratio 10 upstream oil & gas sw 20 yuji murakami pressure distribution drilling operation directional drilling fluid dynamics spe 54334 permeability...

... the well at steady state condition by solving the Laplace equation for incompressible fluid with uniform flux boundary conditions at the well. Because of the difficulty of the simultaneous determinations of both the pressure distribution and the shape of the cone, they also assumed that the potential...

... production rate pressure drop spe 28801 perforation surface roughness reservoir surveillance pressure distribution production performance production monitoring production control well performance inflow performance distribution reservoir simulation roughness oil well production performance...

.... These calculation results are compared with those obtained from the experiments or fine grid simulations. Physical meanings of the shape factor, σ , are discussed on the basis of this comparison. pressure distribution flow in porous media fracture matrix boundary saturation upstream oil & gas...