... artificial intelligence platform subsea system residual capacity compressive strength bond strength long length tubular grouted connection platform-x wellhead platform offshore structure connection length adnoc offshore strength grouted connection test result core sample grout strength...

... and perform numerical simulations, reliable relative permeability data is crucial. Unsteady-state or steady-state displacement methods are commonly used in the laboratory to measure water-oil relative permeability curves of a core sample. Experimentally, the unsteady-state core flood technique is more...

... characterization enhanced recovery flow in porous media upstream oil & gas oil reservoir matrix oil recovery chang 8 fracture tight oil reservoir production rate ethylenediamine permeability core sample starch gel Introduction In recent years, Sinopec newly discovered resouces are mainly...

... ingredient enlargement society of petroleum engineers well intervention acidizing fluid dynamics water saturation treatment fluid core sample permeability pressure drop rock mineral dissolution injection Introduction The decline in oil and gas production from conventional resources...

... layer shallow gas fracture geometry core sample permeability fracture static property society of petroleum engineers Introduction Shallow gas reservoirs can present a number of challenges for effective exploitation, particularly if propped fracturing is required for production ( Figure 1...

... injection recorded the highest decline at 36cm 3 cushion volume, presenting a 48 and 28% reduction in longitudinal dispersion coefficient for Bandera and Bentheimer core samples respectively, compared to that of conventional/traditional CO 2 injection (with zero cushion volume). Recording lower nascent CO...

.... For lithology delineation, intact core samples were scanned utilizing MicroXRF. While, REP was measured using Autoscan and AutoLab systems. The Autoscan employs non- destructive technique to characterize the variability of REP. The AutoLab uses the standard triaxial testing method to provide REP at reservoir...

... at reservoir conditions of 120 C and 4000 psi. All core floods were performed using 30 cm long and 2 inch diameter core samples. In addition, fluid-fluid interaction experiments were performed using fluids from more than 20 carbonate reservoirs in Abu Dhabi. The fluid-fluid experiments were performed...

... Drillstem Testing solubility test Upstream Oil & Gas instantaneous shut-in pressure operation surface condition good alternative BPM core sample society of petroleum engineers acid-fracturing technique conductivity Pump Rate Mexico minifrac test acid surface pressure fracture...

... and transported without special safety precautions. Unlike conventional HCl acid stimulation, GLDA acid is more expensive hence; a comprehensive process was adopted to ensure the proper candidate selection. For compatability study, the core samples from multiple reservoirs were tested with GLDA acid which showed...

... cyclic loading cyclic injection breakdown pressure hydraulic fracturing strength Exhibition reduce breakdown pressure core sample wellbore integrity unconventional resource society of petroleum engineers unconventional rock reservoir psia cement sample application loading fracture...

... difficult the interpretation of NMR measurements from the laboratory as well downhole. We present two case studies: one focused on determining water saturation (Sw) in core samples in a water-oil displacement experiment in the laboratory; the second is about determining the permeability by identifying OBMF...

... water expansion sandengen low-salinity spontaneous imbibition connate water expansion low-salinity water oil production low-salinity mechanism core sample Oil Recovery amott cell spontaneous imbibition Introduction Low-salinity waterflooding is an enhanced oil recovery (EOR) technique...

... to clean out and recomplete the well. This phenonmenon was further confirmed by several experiments performed on different core samples in the Lab. A quick and cost effective solution was looked into and found that 4-1/2" liner, called "drop-off", can be run and set in the upper drain of the well to avoid...

... is important to understand the rudist-bearing carbonate reservoir features for oil exploration and development. However, it is difficult to understand these characters of rudists because we can't collect whole rudist samples from the underground oil and gas reservoirs through core sample. X-ray CT is a useful...

.... The procedure consists of two-part workflow. The first part describes the acquisition of a data base that includes high-quality laboratory NMR and capillary pressure measurements to determine the pore aspect ratio and the effect of temperature on the formation's NMR properties using core samples from the target...

... -alkanes, isoprenoids, steranes and triterpanes) of crude oils from shallow marine porous limestone and core samples from deep marine lime mudstone were determined using gas chromatography-mass spectrometry (GC/MS), gas chromatography-mass spectrometry-mass spectrometry (GC/MS/MS) and gas chromatography...

... Abstract Conventional coring does not provide core samples that are characteristic of the original formation condition. Thus, pressurized coring is required to capture samples that represent the in-situ composition of gases and liquids; pressure, volume, and temperature (PVT) data of the fluids...

... is applied to history match the pressure decline curve. We aimed to fill the gaps using Radial Constant Volume Diffusion (RCVD) method experimentally to investigate diffusion coefficients at different pressures in hydrocarbon saturated porous media. A special in-house cell is designed to hold the core sample...

... ml/min on Grey Berea sandstone core sample with the sample situated in both vertical and horizontal orientations. It was observed that at higher temperature (50°C) suitable for many gas reservoirs, the disperstion coefficient increased significantly compared to our earlier work ( Abba, Abbas...