... meet pre-agreed acceptance criteria. The IPM approach is a typical example of an Outcome Based Contract. In such contracts there are minimum client/ contractor interfaces, and the contractor has a vested interest in optimizing performance as payment is linked to pre-defined acceptance criteria...

... acceptance criteria Introduction This paper provides an overview of the completion technology development journey that enabled a well operator to move from a two-trip to a single-trip completion solution for ERD wells of more than 45,000 ft MD. Upper completion technology was developed specifically...

... was performed for the stack cladding. As this analysis was non-conventional, there is no well-established industry acceptance criteria for the analysis results. Hence, an acceptance criteria was jointly developed with Contractor, which is fundamentally the minimum number of screws per panel, required...

... to 250Hv0.1 has been measured in the heat affected zone. Company and [ 2 ] acceptance criteria is based on macro hardness and these results were considered acceptable. Abstract In the wake of failures of large diameter pipelines made from plates using the Thermo-Mechanically Controlled Process (TMCP...

... of fire, fire duration, heat flux, rupture acceptance criteria, in addition to inputs considered in conventional approach. Emergency depressurization rate in FRA Study is established based on adequacy of ultimate material tensile strength against the stresses developed under fire scenario. In house case...

... of PWHT shall be evaluated by demonstrating an alternate method using fracture mechanics duly supplemented with engineering assessment. Results from the case study substantiated by detailed engineering critically assessment (ECA) show that the acceptance criteria can be achieved without the requirement...

.... This is achieved through a detailed validation programme using the project specific welding procedure and pipe material representing actual pipelay scenario. weld defect height project specific aut Probe defect macro fabrication calibration block Acceptance Criteria reflector Upstream Oil & Gas...

... based on realistic data or assumptions and best practice engineering tools as well. Unfortunately, both data and interpretative models are affected by uncertainties, subjective interpretations as well. About acceptance criteria, international codes recently introduced safety targets applicable...

... Abstract There is an absence of industry-wide, globally accepted standards that provide comprehensive inspection procedures and acceptance criteria for inspection and maintenance of drilling bits, including: wear, cracking, and mechanical damage criteria for bit bodies and cutting elements...

... Management sour service contractor operator Upstream Oil & Gas pipe wall steel Acceptance Criteria hydrogen partial pressure Welding Introduction It is not new that internal corrosion may be of major concern for field development projects. Actually, what is noteworthy is the large...

... and developed an Internal Commissioning & Hand over strategy as follows: At FEED stage of the project, all Commissioning requirments, Start-Up sequence, Performance Test Run requirements & Acceptance criteria are identified and ensured that the same are embedded in EPC scope of work. At early stage...

... In order, therefore, to meet the objective of „consistent minimum reliability (against environmental overload) for offshore platforms around the world’ one possible approach is to specify acceptance criteria that are regionally specific i.e. acceptance criteria that take account of the slope...