Surfactant/polymer (SP) and alkali/surfactant/polymer flooding is of current interest because of the need to recover residual oil after primary and secondary recovery. If designed properly, these enhanced-oil-recovery processes can give very high oil recoveries. Microemulsion phase behavior plays a central role in process performance and is typically measured by performing salinity scans in glass pipettes at atmospheric pressure and reservoir temperature using dead crude oil from the reservoir of interest. There have been only a few experiments reported in the literature on live oil at reservoir pressure and temperature, and the importance of those experimental results is conflicting.

This paper investigates the effect of pressure and solution gas on microemulsion phase behavior and its impact on oil recovery. We examine previous data reported in the literature, and report new measurements with live oil to show that the optimum parameters can change significantly. The experiments show that while pressure induces a phase transition from upper microemulsion (Winsor Type II+) to lower microemulsion (Winsor Type II—), solution gas does the opposite. An increase in pressure decreases the optimum solubilization ratio and shifts the optimum salinity to a larger value. Adding methane to dead oil at constant pressure does the reverse. Thus, these effects are coupled and both must be taken into account. Using a numerical simulator, we show that these changes in the optimum conditions can significantly impact oil recovery if not accounted for in the SP design.

You can access this article if you purchase or spend a download.