... simulation recovery southern dome artificial intelligence reservoir model modeling & simulation water cut PAPER 2009-022 Integrating Geological Characterization and Historical Production Analysis to Optimize Field Management of Lower Miocene Reservoir in White Tiger Field, Vietnam N.T.B. NGUYEN...

... service contract south region mpfm pressure drillstem/well testing production test flowstream upstream oil & gas accuracy flow metering production control production monitoring water cut difference error reservoir surveillance repeatability test information application real time...

... as the water ratio reached 98%. Crosslinked polymer injection was introduced after the water cut was as high as 90%, and stopped as the water cut reached 98%. It was found that most of the residual oil after polymer flooding existed in small areas far away from the diagonal line for heterogeneous reservoirs...

... is very low, but also the water cut increase is extremely rapid. The presented simulation study investigates dynamics of productivity loss in wells producing heavy oil with bottom water. The production system (nodal) analysis model simulates inflow performance relationship with variable water cut...

... of this oil with cost intensive new wells drilled through new platform will hardly satisfy the investment decision. The repositioning through short/medium radius drain-hole completions (SRDH/MRDH) of suboptimally/ high water cut wells that have drained the oil from their drainage area enhances production...

... completion bottom-water system production rate reservoir simulation wojtanowicz completion modeling & simulation water invasion dimensionless group penetration permeability water cut grid block enhanced recovery well penetration upstream oil & gas top completion completion strategy...

... upstream oil & gas aggregate oil source cadwasp water cut production history screening completion PETROLEUM SOCIETY CANADIAN INSTITUTE OF MINING, METALLURGY & PETROLEUM PAPER 2006-176 Candidate Acquisition of Downhole Water Sink Potential (CadWasp) Initial Development of an Expert System...

... of a simulation study aimed at understanding the relationship between water cut development and oil bypassing. Water cut vs. time plots obtained for different reservoir conditions have been analyzed as potential diagnostic tools for the oil recovery process. The results show that there is good correlation...

... responses were selected, 6 factors were examined, 16 cases were executed to find main relations between factors and responses. The results indicated that water saturation in transition zone may affect water cut in spite of transition zone thickness. Secondly, the growth of the dynamic water saturation...

... well penetration production rate water breakthrough time viscosity water cut enhanced recovery flow in porous media permeability displacement reservoir breakthrough fluid dynamics modeling & simulation conformance improvement breakthrough time dietz bypassed oil penetration...

... Abstract This paper demonstrates the benefits to be gained from performance analysis of gas-lifted vertical and horizontal wells in Hassi R'mel oil rim, where significant incremental oil production rate can be achieved as water-cut increases and reservoir pressure declines by a comprehensive...

... water cut mobility ratio abandonment well location flow in porous media breakthrough reservoir interface PETROLEUM SOCIETY CANADIAN INSTITUTE OF MINING, METALLURGY & PETROLEUM PAPER 2004-269 Early Water Production and Bypassed Oil in Edge Water Drive Reservoirs O. ARSLAN, A.K. WOJTANOWICZ...

... potential exploitation opportunities to explore. geological layer frobisher cumulative oil production waterflood kisbey field base case fluid dynamics history match permeability kisbey alida water cut porosity oil production reservoir characterization upstream oil & gas recovery...

... have shown the extremely low permeability of shale body. This fact and other relevant factors are comprehensively considered when horizontal well technology is applied to develop the bottom-water reservoirs. For all of the simulation cases studied, the results have indicated that water cut can...

... of gel on low permeability zones. Gel treatment shows better efficiency in low water-cut stage thanthat in high water cut stage, but potential damage of gel on low permeability zones will limit gel application in early stage of oilfield development if gel is injected without zone isolation. The damage...

... & simulation upstream oil & gas water cut reservoir simulation pressure curve PETROLEUM SOCIETY CANADIAN INSTITUTE OF MINING, METALLURGY & PETROLEUM PAPER 2004-146 Upscaling of Oil-Water Displacement in Naturally Fractured Reservoirs J. XIE, M. POOLADI-DARVISH University of Calgary This paper...

... Abstract Senlac/Winter horizontal well performance is characterized by a short period of high-oil-cut production followed by water cut increases over a several month period to very high water cuts. Previously the more viscous high-oil-cut fluids have typically been trucked to more distant...

... and an interface to a commercial reservoir simulator have been written and used as a numerical tool for DWS well performance analysis and design. The tool captures hydrodynamic interaction between the two completions of the well in terms of pressure interference, water saturation (coning), and producing water cut...

... conformance improvement placement water cut shrinkage enhanced recovery viscosity flow in porous media water shut-off treatment differential pressure PETROLEUM SOCIETY CANADIAN INSTITUTE OF MINING, METALLURGY & PETROLEUM PAPER 2002-031 Production Well Water Coning Is There Anything We Can Do? F.B...

... incremental recovery producer injection flood polymer flood experiment cumulative oil production enhanced recovery ooip water cut PETROLEUM SOCIETY CANADIAN INSTITUTE OF MINING, METALLURGY & PETROLEUM PAPER 2002-079 Preliminary Laboratory Evaluation of Cold and Post-Cold Production Methods...