Abstract

A fast and accurate method for the group analysis of crude oils in porous media that describes petroleum components (especially heavy fractions) has been developed NMR structure group analysis is used as the tool for the characterization of crude oils. This method is proposed as an alternative to existing complicated and laborious methods of characterization of extracted oil samples. Currently, group analysis of heavy fractions of crude oils is being investigated by means of chromatographic method such as the SARA (saturates-aromatics-resins-asphaltenes) test. These methods are usually expensive and require considerable work from qualified personnel. Furthermore, these methods cannot be used for estimating the oil components in-situ.

The basis of determining crude oil components using NMR is the difference of the nuclei mobility in the different hydrocarbons during the NMR testing period A combination of solvent extraction, NMR testing and data processing gives a series of NMR terms that are then used to specify hydrocarbon mixtures and their components both in the bulk phase and in unconsolidated porous media.

Introduction

NMR logging tools are currently used for determining reservoir properties such as porosity12, permeability1,2,3,4,, as well as mobile and immobile fluids5,7. Recent developments in NMR research offer tools for separating water, oil and gas from the combined NMR signal8,9. Very little is known about the use of NMR logging tools for the in-situ characterization of crude oils1. With respect to heavy oil and bitumen formations, NMR logging has not been very successful in characterizing crude oil. The reason for the lack of such success is the fact that the spectra from most of heavy oil and bitumen formations cannot be detected by the NMR logging tools. It should be noted that high field NMR technology has solved such problems in the past, but such technology cannot be used down hole.

A fundamental objective of the research performed in our laboratory is to extend the use of NMR logging tools to all heavy oil and bitumen formations. To this end, the NMR characteristics of heavy oils in porous media were investigated10,11. The objective of our work is to isolate the oil signal from the combine NMR spectrum of the formation and then shift it towards the relaxation time range that can be detected by the conventional NMR logging tools. Once this goal is achieved, NMR logs of heavy oil and bitumen formations can become successful in the in-situ analysis of oil.

This objective was accomplished in the material presented in this paper through a series of experiments that addressed the following issues:

  • Relaxation interactions in mixtures of simple organic liquids with water.

  • Relaxation interactions in mixtures of simple organic liquids.

  • Relaxation interactions in mixtures of simple organic liquids with solvents.

  • Relaxation times of conventional crude oils with and without solvents present.

  • Relaxation times of heavy crude oils and bitumen with and without solvents present.

  • Relaxation times of heavy crude oils and bitumen with and without solvents in unconsolidated sands and with variable connate water saturation.

This content is only available via PDF.
You can access this article if you purchase or spend a download.