... loop was designed to maintain a flow rate of 0.03-0.04 m 3 /sec, pressure of 3300kPa and temperature of 150°C to simulate actual field condition. Test section consisting of two 35" straight tubes with 45° elbow was internally coated and connected to the flow loop which was run continuously for 14 days...

... with water. Therefore, the tests were naturally conducted using water filled flow loop. In the test loop there were three test sections with known deposit thickness and the estimated deposit thickness values are compared to the actual values. In the tests the sensor flows inside the pipe and the flow speed...

... multiphase flow plif measurement approach light intensity plif measurement technique test condition test section optimized plif measurement technique camera filter mixture density reference measurement commercially available reference instrumentation measurement approach recording period...

...) injected, a newly- constructed jumper-like facility (the HyJump flowloop) has been developed in Perth, to simulate shut-down and restart operations over a range of superficial gas velocities. The test section of the flowloop has a unique geometry to mimic subsea jumpers, with three low points and two high...

... section consists of a U-bend constructed from 4-inch pipe. Liquid slugs were propelled through the piping by gas pressure and the structural response of the test section was measured as the slugs traversed a series of 90° pipe bends. As a basis for the test programme, slug lengths and velocities of up...

... drop production monitoring separation efficiency test section production control bulk de-oiling efficiency hydrocyclone de-oiling unit bulk de-oiling cyclone efficiency underflow separation and treating reservoir surveillance concentration qualification hydrocyclone liner water...

... stress thickness soedarmo flow loop upstream oil & gas mass density production control test section hydrodynamic parameter offshore technology conference reynolds number Soedarmo , Auzan Abirama . 2015 . Mechanistic Study of Wax Deposition: Boundary Layer and Deposit...

... and will encompass a large volume of solvent inside it. Experimental Program Loop Sections A lab-scale experimental loop (Figure 1) was designed and constructed to carry out this study. This loop consists of the following major sections: 1) Reservoir 2) Heater and Pump Assembly 3) Test Section 4) Chiller for Heater...

...) was improved and used in this study. This facility consists of (1) oil system, (2) gas system, (3) gas-liquid separation system, (4) hot glycol system, (5) cold glycol system, (6) data acquisition system, and (7) test section. The overall process diagram of the multiphase facility is shown in Fig. 2. Oil...

... or modules will result in greater current loads exerted on the pipe, increasing the drag area. A 1:40 ratio model test has been performed to investigate the excitation of VIV to the step riser configuration. The test section was composed of flexible riser, buoyancy cans, endfitting and its vicinity area...

... surveillance surface roughness flow rate inner wall temperature deposition zone hernandez production monitoring roughness upstream oil & gas deposit investigation panacharoensawad test section deposit surface roughness pressure drop water cut flow direction production logging production...

... to characterize the two-phase flow behavior for the entire range of possible viscosities. A systematic experimental program on medium oil viscosities (39 cP<µO<166 cP) is presented in this study. The experiments are performed using a flow loop with a test section of 50.8-mm ID and 18.9-m-long horizontal...

... shear stress reservoir surveillance reynolds number pressure drop method test section upstream oil & gas entrained oil pipe deposit thickness production control flow condition flow assurance deposition deposit mass south pelto oil otc 22953 experiment shear stress production...

... model oil viscosity viscosity prediction university of tulsa production control pipe pressure drop superficial gas velocity removable spool piece production logging test section correlation production monitoring holdup flow pattern pressure gradient offshore technology conference...

... then burn back to the LNG pool, in which case a pool fire ensues. test section water surface relative speed interface cryogenic pool lng vaporization rate ln 2 assumption otc 19561 klimenko water speed midstream oil & gas cryogenic liquid pool offshore technology conference...

... gas chromatography migration test section brownian diffusion particle transport production logging upstream oil & gas particle distribution pipeline experiment otc 18368 deposition offshore technology conference model oil scandpower petroleum technology inc reservoir...

... temperature deposition pipeline production monitoring test section experiment production control cold wall deposition process magnification deposition mechanism deposition thickness upstream oil & gas channel flow molecular diffusion otc 17081 production logging copper wall mechanism...

... liquified natural gas contraction astro technology terminal midstream oil & gas us government test section configuration OTC 17338 An Ambient Pressure Insulated LNG Pipeline for Subsea Environments C.N. Prescott and J. Zhang, Fluor Corp., and D.V. Brower, Astro Technology, Inc. Copyright 2005...

... reduction," the blockage cleared safely with a 138-bar (2,000-psi) pressure difference across the test section. The pressure difference across the test section dropped to a few bar within 4 seconds of blockage freeing. The clearing time for a similar blockage in a large (300-km long, 24-inch) deepwater line...

... exists for thecategorisation of wave patterns nomenclature horizontal pipe wall friction factor donnelly reservoir surveillance otc 7743 prediction test section production control production monitoring friction factor pressure loss multiphase flow flow regime pipe shear stress...