1-20 of 79
Keywords: probe
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 6–9, 2024
Paper Number: OTC-35055-MS
... for dense gas application. geologist hydraulic jet pump salt tectonics structural geology operation subsea system vibration artificial lift system slug probe offshore technology conference compressors engines and turbines multiphase pump prediction unbalance validate dense phase fluid...
Proceedings Papers

Paper presented at the Offshore Technology Conference, August 16–19, 2021
Paper Number: OTC-30955-MS
... to produce deeper and further reservoirs in a constant evolutive oil and gas market. multiphase pump clearance operation barrier fluid hydraulic jet pump performance prediction artificial lift system qualification test seal face shaft upstream oil & gas proximity probe requirement...
Proceedings Papers

Paper presented at the Offshore Technology Conference, April 30–May 3, 2018
Paper Number: OTC-28696-MS
... in the moonpool is initialized at Z = 10m while the water surface around the FPSO hull is Z = 0m. There are five numerical probes placed in the moonpool, one at the center and four around the wall, as shown in Figure 3. The coordinates of the center of the moonpool are denoted as (Xc, Yc). The notation...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 1–4, 2017
Paper Number: OTC-27900-MS
... characteristic upstream oil & gas reservoir surveillance average liquid film velocity separator flow rate film depth probe Cremaschi , S. , Kouba , G. E. , and Subramani , H.J. , Energy & Fuels , 2012 . Pereyra , E. , Torres , C. , Mohan , R. , Gomez , L...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 1–4, 2017
Paper Number: OTC-27563-MS
... propellant ignition sandstone block experiment probe perpendicular wellbore tooth pattern bi-wing fracture cuderman horizontal stress propellant hydraulic fracturing Hamdan , V.H. , Jumaat , M.S. , Samsu , M. and Trebolle , R. 2012 . Propellant Treatment to Clean Out...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 2–5, 2016
Paper Number: OTC-27060-MS
... of the cement in place. The well was installed in soft swelling clay soils to investigate the sensitivity of the smart oil well cement. A new method has been developed to measure the electrical resistivity of the materials using the two probe method. Using the new concept, it has been proven...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 5–8, 2014
Paper Number: OTC-25334-MS
... armour wire inspection buttle riser electromagnetic stress measurement technology application probe armour wire layer wire layer tensile armour wire layer flexible riser upstream oil & gas wire movement offshore application wire break flexible pipe offshore technology...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 6–9, 2013
Paper Number: OTC-23973-MS
... fields such as Bonga and Kizomba Satellite. defect acceptance criteria aut system outer pipe assessment pip system weld pipe loading inner pipe swaged weld defect size geometry inspection probe field joint defect position otc 23973 piping design detection upstream oil...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 6–9, 2013
Paper Number: OTC-24059-MS
... for specifying the equipment, positioning the system with NDT measurement tools (CP and US probes, magnetic sensing), HP cleaning and operational deployment. It also presents the results of various qualification tests carried out in the laboratory and the harbor to develop this new technology...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 6–9, 2013
Paper Number: OTC-24124-MS
... Abstract The paper describes operational details and performance results of a new deepwater seismic probe for measuring the in situ shear wave velocity (Vs) of offshore soils. The system uses a seismic cone that incorporates two sets of geophones located 1 m apart in the probe so as to allow...
Proceedings Papers

Paper presented at the Offshore Technology Conference, April 30–May 3, 2012
Paper Number: OTC-23464-MS
... technology, Phased Array (PA)AUT. Phased Array enables use of a single probe to send ultrasonic waves atmultiple angles, achieving the same results that would take multipleconventional ultrasonic probes to deliver. Fundamentally, the physics of ultrasonics is no different between conventionalpulse echo...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 2–5, 2011
Paper Number: OTC-21301-MS
... formation pore pressure wellbore design diameter clay shale formation in-situ pore pressure piezoprobe dissipation offshore technology conference wellbore integrity drilling peuchen reservoir characterization probe sediment well logging pore pressure measurement pore pressure...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 3–6, 2010
Paper Number: OTC-20464-MS
... production chemistry mullin hydrate inhibition asphaltene distribution hydrate remediation otc 20464 probe black oil asphaltene nanoaggregate asphaltene remediation equilibrium upstream oil & gas asphaltene concentration scale inhibition scale remediation nanoaggregate wax...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 4–7, 2009
Paper Number: OTC-20004-MS
... on a simplified riser to investigate the magnetic response. The modelling revealed the complex pattern of the magnetic flux and induced eddy-currents in the wires and allowed the interaction of the probe, stress and geometric variations in the riser to be investigated. Figure 3 shows the magnetic flux induced...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 4–7, 2009
Paper Number: OTC-20024-MS
... laboratory measurements may be uncertain or even useless. A recently introduced focused probe technology for WFT tools has greatly improved the quality of oil samples acquired in wells drilled with OBM and has also reduced the time to acquire them. This probe has been very successfully deployed in a number...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 1–4, 2006
Paper Number: OTC-18201-MS
... drilling fluid chemistry probe formation testing flowline sample flowline optical density value obm filtrate guard flowline contamination upstream oil & gas color channel optical density technology conference contamination level drilling fluids and materials optical color...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 3–6, 2004
Paper Number: OTC-16106-MS
... accuracy. Full area coverage of exposed vessel areas. Large measurement range. Possible to calibrate online against fixed targets. Cons: Large number of sensors, complicated electronics. Swept Capacitance probe As the permittivity of water and sand are different, a permittivity measurement between a sensor...
Proceedings Papers

Paper presented at the Offshore Technology Conference, May 5–8, 2003
Paper Number: OTC-15324-MS
... (surface read-out) data. In the past, in order to obtain this type of data, either a downhole latching system or a download probe in close proximity to the transmitting device had to be used. This acoustic data- acquisition system provides access to real-time bottomhole data using either a wireline...
Proceedings Papers

Paper presented at the Offshore Technology Conference, April 30–May 3, 2001
Paper Number: OTC-13098-MS
... island offshore technology conference replenishment beach replenishment penetration probe characteristic otc 13098 video camera pneumatic hammer water depth application prototype system cruickshank characterization sensor hammer system testing Copyright 2001, Offshore...

Product(s) added to cart

Close Modal