... for hydrate remediation and the engineering study that was conducted to assess the risks. hydrate plug upstream oil & gas pressure increase offshore technology conference deepwater hydrate plug remediation gas lift remediation displacement plet displacement flowline fundamental physics...

... reservoir. Fracturing of the caprock from the CO2 injection could thus result in CO2 leakage to the overlying producing reservoir. The CO2 injection resulted in an initial well pressure increase, probably caused by precipitation of salt in the near wellbore area. This challenge was resolved by injection...

... Abstract Subsea boosting of hydrocarbon flow, either directly from the well or from a subsea separator, will typically result in the need of handling some free gas. Pumping moderate gas volume fractions (GVF) in combination with high pressure increase, is typical for boosting flow from deep...

... reservoir surveillance enhanced recovery field-wide interference test hydraulic communication drillstem/well testing communication production control pressure increase production monitoring smart completion observation well natural fracture producer inter-reservoir communication drillstem...

... capacity compressibility average pressure increase injectivity enhanced recovery subsurface storage otc 19309 reservoir characterization permeability reservoir simulation co 2 van der meer storage capacity storage potential upstream oil & gas conductivity offshore technology conference...

... consider the weak wall configuration because of a less critical pressure increase. · The pressure level on the other side of the wall usually decreases with both the weak and the strong wall. In that case, we did not observe an explosion and flame propagation behind the blast wall in case of full gas...

... the stroke of the pinger reduces the volume available for the liquid system so the pressure increases. In this case the initial pressure is 47 psi and after equilibrium is reached the system pressure is about 75 psi (delta pressure = 28 psi). Using the bulk modulus of water and the displacement...

... be speci- fied and illustrated by a few values of pressures and flow rates. For example, a system with a rated flow of 25,000 bb1/day, having to produce a pressure increase of 20 bars at a mean GLR* in steady-state flow of 10 volume/volume mesured at suction pressure, must be able to ensure: o Under start...