... australia government motion performance requirement portside loading condition sponson design model test design requirement riser offshore technology conference floating production system floating production storage & offloading mero 3 impact load operation roll motion riser balcony...

... examples attributed to human error attributed to poor user interface. The challenge, however, is the ability of systems designer to accurately and completely specify the design requirements to address safe human interaction with the system. [1]. Implementing HSI ensures that the technical and management...

... incorporated into offshore floating drilling practices. subsea well intervention system factory acceptance testing upstream oil & gas subsea production equipment design requirement subsea well intervention equipment manufacturer subsea system functional requirement end user safety function...

.... This is the first development to incorporate post-Katrina environmental design loads and new regulatory design requirements. Project challenges include numerous technical challenges pertaining to well designs for 24 DVA wells targeting over 50 horizons spanning 10, 500 ft TVD to approximately 25, 000 ft TVD...

... tensions and offset limits according to the latest industry standard for a permanent mooring system. Since the existing mooring system marginally failed the design requirements based on the evaluation, system optimization design focused on the adjustment of mooring line pretensions has been carried out...

... is discussed in relation to welding process limitations, material limitations and availability of suitable consumables. Several examples are presented that illustrate the problems associated with meeting design requirements. Introduction Welding is performed for a variety of purposes such as (1) meeting...

... carried out to verify the adequacy of design load conditions and structural design requirements of the ABS WSD-based design criteria. Metocean conditions in the US Gulf of Mexico (GoM) and East Coast were used in the calibrations to calculate the aerodynamic and hydrodynamic loads as well...

... rp 2fp design requirement upstream oil & gas fpso deck clearance structure design guidance subsea system wrapper api bulletin offshore structure standard safety factor tlp otc 19603 offshore structure hurricane season artificial intelligence platform task group offshore...

.... agencies. Wind power generators have been designed, installed and have provided many years of service in land-based wind farms. This experience has provided the industry with the basis of understanding of complex wind loading and the associated design requirements for the generator, its support structure...

.... The abstract must contain conspicuous acknowledgment of where and by whom the paper was presented. Abstract The feasibility, weight and cost of steel risers in ultra- deep water depends critically on the design requirements for resisting functional loads due to internal and external pressure combined...

... design method criteria design requirement regulation inspection society rule north sea mooring system upstream oil & gas structural design requirement partial factor subsea system industry standard otc 8420 technical panel mechanical system consistent level riser design...

... platform cable disconnection water management storm weather condition vfb design requirement enhanced recovery subsea system artificial lift system aTe 6306 The Veslefrikk Transfer Systems O. Bjelland, Statoil AlS Copyright 1990, Offshore Technology Conference This paper was presented...

... approximately 95m below sea level on a fixed production platform. An L-shaped crack, 275 mm long and completely contained within the dent, also resulted from the impact. An analysis that considered the damaged cross brace non-functional showed that the platform did not fully meet the initial design requirements...

... gas injection stab problem area electrical connector occidental petroleum wellhead completion equipment stab block operator flowline stab enhanced recovery upstream oil & gas design requirement vendor connector gas lift valve scapa template crossover base subsea system...

... obtained. In addition, the task of ensuring that design requirements were met during manufacture and installation wi11 al so be discussed and solutions, in particular the purpose designed electronic gauging system, described. INTROUCTION Installation of the TLP at the Hutton Field was completed...

...OFFSHORE TECHNOLOGY CONFERENCE 6200 North Central Expressway Dallas, Texas 75206 PAPER NUMBER aTe 2483 Design Requirements For A Major Offshore Process i ng Fac iii ty By W. B. Cook, Fluor Ocean .Services, W. M. Prindible, Atlantic Richfield, and U . u lng. Bambang Sumantri, Pertami na THIS PAPER...