... amplitude roll motion carriage fpso floating production storage and offloading experiment liquid cargo cargo tank ballast tank subsea system floating production system polar engineering conference international offshore loading condition motion response Table 4 Cargo Tanks Loading...

... responsibility carriage offshore wind power depend rotor equinor water depth capacity factor subsea system significant challenge platform sustainable development wind farm wind turbine sustainability demonstration project offshore technology conference turbine wind energy renewable energy...

... that is nearing the end of its primary hull construction, presents challenges to the design and construction team. The support carriages for the ADCPs required to monitor the water depth of today's floating facilities can weight up to 4,000 lbs. The structures that support these carriages have a significant...

... relative to R1. diameter riser current velocity deepsea riser collision transducer instrumentation test program collision otc 11993 pretension strake configuration force impulse collision energy collision force offshore technology conference carriage downstream riser Copyright...

... deflection cable carriage receiver operation connector offshore operation rov contingency deflection cable upstream oil & gas procedure bottom friction condition deepwater tie-in operation offshore pipeline collet connector otc 7300 tie-in operation winch tooling OTC...

.... The complete system is made up of a derrick with pipe handling boom and grabs, strongback storage with carriages and ancillary equipment. Drillpipe, tools and collars will be stored either side. The boom can be rotated in a slewing motion and lowered in a luffing motion. The automated pipe handling...

... underwater carriage seabed pipeline carriage upstream oil & gas coefficient time series pipe rough bottom offshore pipeline diameter large-scale laboratory experiment test condition lift force oscillatory velocity trench vertical force hydrodynamic force laboratory...

... measurements and the horizontal and vertical movements of the pipe. The test rig consisted of a steel carriage (length x width x height ~ 3.3 x 3.3 x 2.0 m) made up of square - pipes (80 x 80 x 5.6 mm). The rotational rigidity of the pipe section was secured by a suspension assembly attached to the pipe...

.... It consists of a relatively stiff lathe bed (42 in. long) together with its carriage and cross slide (see fig. 4). A flat solid cap is epoxied at each end of the test specimen. The assembly is then placed between two centers located at each end of the lathe bed. This arrangement allows free' rotation...

... and physical model testing to establish the magnitude of the hydrodynamic forces. The paper describes in detail the hydrodynamic model testing. By using the carriage technique, scales varying from 1: 1 to 1: 4 have been obtained in the laboratory. Further by applying directly measured wave induced bottom...

... operation connector grondin northeast experimental station valve manifold upstream oil & gas subsea processing surface support manipulator objective carriage safety valve hydraulic power unit subsea station subsea system experimentation grondin subsea station installation OTe 3997...

... lifting beam girder carriage pipe pipe end upstream oil & gas operation anti-corrosion coating pipeline repair system module rotation girder machining offshore pipeline preparation OTC 4029 AUTOMATIC DEEP WATER PIPELINE REPAIR SYSTEM by Jean-Louis Migliarese, Compagnie Francaise des...

.... carriage pipeline upstream oil & gas directional drilling shore approach problem offshore pipeline proceedings rig hydraulic motor directionally obstacle landing pipeline adverse environment river pipeline river specialty conference beach cross-section control cab shoreline...

... gasline weld carriage pipe OTC 3346 DEVELOPMENT OF CONTROLLED HARDNESS AUTOMATIC WELDING FOR THE FLAGS GASLINE by R. L. Jones, GRG-Automatic Welding, D. K. Kiltau, Shell U.K. Exploration and Production Go., and K. P. Havik, Semac Services, B.V. " Copyright 1978, Offshore Technology Conference...

... components. selection lifting head racker servo system drilling operation computer control servo system valve well centerline computer position information elevator driller carriage sequence malfunction upstream oil & gas information pipe racker engineer OFFSHORE TECHNOLGGY...

... mechanical coupling water depth vehicle cable procedure diameter diver repair system pipe section sprt carriage positioning guideline replacement pipe section requirement upstream oil & gas offshore pipeline operation investigation OFFSHORE TECHNOLOGY CONFERENCE 6200...

... operation carriage institute winch reservoir characterization air compressor hudson handler upstream oil & gas personnel deckhouse navigation corer OFFSHORE TECHNOLOGY CONFERENCE 6200 North Central Expressway Dallas, Texas. 75206· THIS IS A PREPRINT SUBJECT TO CORRECTION ~OTC 1631 Core...

... into a storage hopper. The method of pumping used in the test was an air-lift system. Flow in the pipe is induced by continuous injection of air into the pipe at a depth of 1/3 to 1/2 the depth of the ocean. ocean mining carriage instrument pup cable dredge pipe manufacturer operation derrick...

... and location depends on cooperative targets. An accoustic pinger is installed in the torpedo prior to firing; hydrophones are mounted on the underwater recovery carriage enabling the recovery crew to merely "home-in" on the pingers. All of the torpedo ranges are equipped with underwater tracking systems, thus...