... capabilities requirements in Marjan field. The purpose of composite cables is to feed power from onshore substation in Tanajib, KSA to GOSP-4 offshore facility. Each composite cable is 89 km in length and approx. 7,000 MT of weight. The requirement from Client is to lay both cables without any field joints...

...-based asset integrity enhanced recovery simulation approx natural gas storage gas storage operation offshore technology conference pipeline blowdown valve variation high-pressure gas storage transient operation Introduction Operating safely by maintaining the structural integrity...

... deliveries, reduction of the energy consumption and thus lowering the CO 2 emissions. Calculations show that 1 bar pressure drop in the Troll Phase 3 value chain increases the project NPV (8%, pretax) with approx. 45 Million USD and reduces the power consumption by 11 GWh/year. The well tubing size...

...Phase 1 General Information The 1 st (onshore) phase of the project was executed at the Maasvlakte near Rotterdam, The Netherlands. In May 2016 a 27.25 m long monopole (with a weight of approx. 127 tons) was driven to a final penetration of 14.5 m below grade. A schematic view of this pile...

... opportunities Introduction Currently there are more than 5000 subsea wells world wide and the number is growing, particular in areas like West Africa and Brazil. In the North Sea there are approx. 1300 subsea wells of which about 500 are located on the Norwegian Continental shelf (NCS). The intervention...

... operational since March 2005 and is as such the first offshore LNG regasification facility in the world midstream oil & gas vaporizer ship mooring system stl compartment swivel approx excelsior liquified natural gas offshore technology conference stl buoy subsea system tank otc 18398...

... operation shipyard topsides comparison study terminal pipeline approx construction wave height tank sensitivity soil condition liquified natural gas vaporizer otc 16077 installation OTC 16077 Offshore LNG Terminals: Sunk or Floating? Wim van Wijngaarden, Single Buoy Moorings, Inc. (SBM...

... oil & gas subsea system flowrate sensor separator level sensor reliability whfp approx production monitoring flowline vasp application operability reservoir surveillance liquid flowrate separation and treating OTC 8449 Field Tests on VASPS Separation and Pumping System Massimo...

... flow pattern compressor requirement approx separation efficiency cyclone type liquid cyclone offshore technology conference new separator internal cut separation and treating upstream oil & gas flowrate otc 7742 OTC 7742 New separator internals cut revamping costs F. Koene, Burgess...

... in center and the cylinders extending radially around the circumference. Two mud pump configurations have been designed, a three piston and a five piston pump. nozzle drilling mud pump otc 007581 operation drilling mud pump test program drilling mud rubber membrane approx hydraulic oil...

... sufficient holding capacity in the very soft clay. Initially, it was the intention to extract the piles without use of the vibratory hammer, but by pulling vertically with the crane. piles. approx initiation pile operation shear strength installation upstream oil & gas vibratory hammer...

... to the significant influence of sulphur on the toughness of structural steel castings, desulphurisation should already be performed on the hot metal. application toughness mod upstream oil & gas metals & mining steel strength steel casting cast steel approx offshore structure thickness...

... and Zeebrugge. An approx. 200 km section of the North Sea bottom had to be prepared in such a way that the pipe-laying schedule of the lay barge Semac 1 was not jeopardised and post trenching could be executed to achieve the required target line i.e. the bottom of pipeline as specified by the oil company...

... construction site with approx. 1 day in between. Consequently two towing fleets had to be mobilized totalling 18 towing vessels with 2215 t bollard pull, the largest towing fleet ever assembled. At the Ekofisk Field during the approach to the 2/4 Tank the structures had to pass neighbouring installations...

... introduced to reduce development and operating costs and maximize profits. In brief the main achievements can be highlighted as follows (related to the approved FDP of 1984) : (Available in full in paper) LOCATION/NAME The Oseberg field is located approx 60°N, 110 km from the west coast of Norway...

... friction performance cylinder durability actual swivel stationary cylinder reliable multipath swivel approx diameter seal system resistance bearing operation swivel solid lubricant aTe 6166 Development of High-Pressure Seal and Bearing of Reliable Multipath Swivel by O. Saeki, S. Ishibashi...

... detail. frequency premature refusal underwater loss centrifugal force subsea installation operation template installation prediction impact hammer penetration sandlayer approx vibratory hammer hammer programme application resistance tnowave programme upstream oil & gas...

... case history is described in numerous recent publications [4, 7, 8]. statfjord satellite calibration ekofisk pressuretransducer compaction field unit shownon figure5 documentedcase platformdraft reservoir compaction upstream oil & gas investigation otc 5406 platform approx...

... all the elements necessary for installation. The set-down concept was simple and had to be operational by mid September 1984. arctic kiggiak upstream oil & gas otc 4942 positioning system berm caisson mobile arctic caisson molikpaq mac approx operation subsea system draught set...

..., normalized high-strength steels with a minimum yield strength of approx. 350 N/mm 2 and good toughness have been used since the beginning of the offshore activities. During the steelmaking process, a narrow margin of the alloying percentages has to be observed to obtain good welding characteristics...