... is enhanced with the increase of external heat flux. The adsorption coating can effectively prevent the temperature rise in LNG tanks during cryogenic storage. INTRODUCTION The fastest-growing non-renewable energy source in recent years is natural gas, the cleanest fossil fuel(Chong, 2016). Demand...

... but it holds also a risk of CO2 leaking in the sea. CO2 hydrate formation has the potential of solving the problem. The aim of this work is to build CO2 hydrate formation model based on previous studies. In order to determine hydrate growth rate, matching with temperature rise of experimental result, interface...

... for increasing the computational grids in the concerned region (DHI, 2011). buoyant jet trajectory centerline temperature dilution rate plume jet depth-averaged temperature temperature difference buoyant jet center outfall temperature rise buoyancy effect buoyancy similar result theoretical...

... to the intake under adverse sea conditions. intake outfall water management groin salinity outfall intake simulation excess temperature modeling bathymetry outfall channel configuration engineering upstream oil & gas temperature rise power plant red sea discharge water quality...

... heat source model (Man et al, 2011). reservoir surveillance analytical solution ingersoll production monitoring spiral coil source model ground heat exchanger skhan park thermal response test source model spiral coil type ghe heat source production control temperature rise coil type...

... one cycle of friction welding is evaluated through converting a water temperature rise into a water equivalent of a heat. In other words a total heat input teQ (J) is calculated by the following equation: Fig.1 Diagram of variations in friction welding parameters Fig.2 Schematic of the calorimeter...

... the problems of residual stress and/or strain. The second term represents the temperature rise reflected by the two boundaries of plate width. stress distribution experimental data welding direction residual stress satoh welding deformation inherent strain typical point residual stress...

... from the chemical industry, where GRP piping systems have already widely been used, further applications can be expected which will involve process fluids and oil and gas at higher pressures (~10 MPa). pyrolysis temperature rise surface boundary condition decomposition grp panel upstream...

...., 1996). However, sometimes it is not supported with real data, for example, North Atlantic Faroe Islands feature rather temperature decrease than rise (Cappelen, 1999) and Mediterranean Cyprus temperature rises (Price et al., 1999). Meanwhile, involving of aerosols into simulations not only compensates...

... performance synthetic fibre ropes offer design advantages when compared to steel moorings for large floating structures However, with storms of considerable duration being commonplace in the North Sea, it is imperative to ensure that any temperature rise in the rope, due to hysteresis and frictional heating...

... ABSTRACT This paper investigates temperature rise distribution near a crack tip of CT specimens of a mild steel due to plastic work under intermediate loading rate for the purpose of considering the criterion for crack instability under arbitrary loading rate. The dynamic thermal elastoplastic...