... stiffness evaluation year 2048 hydraulic fracture integrity simulator overburden ARMA 22 246 Geomechanical Risks Mitigation for Safe Long Term CO2 Geological Storage Tan, C.P., Ali, S.S., Yakup, M.H., Mustafa, M.A., Chidambaram, P., Azahree, A.I. and Mazeli, A.H. PETRONAS Group Research...

.... The present study evaluates a single tunnel with an overburden of 1000 m and an in-situ stress ratio ranging from 0.25 to 3 to prepare a training and validation set. The results show that with an acceptable 0.1% error, the Levenberg-Marquardt Back-Propagation Method (LMBP) of Artificial Neural Network (ANN...

.... The objective of this work is to present the tests results, how they were performed and the operational problems faced, always seeking the shortest rig time. These results favored the understanding of the reservoir and cap rock behavior. structural geology aperture overburden pressure Upstream Oil...

.... casing shoe depths for XLOT), and in limited numbers. For planning of hydraulic fracture stimulation treatments and for the safe operation of injection wells in fracture modus, the Holy Grail is thus to obtain a continuous stress profile through the overburden and the reservoir. Equinor has put...

... mining. NIOSH and mine personnel discovered that overburden thickness in excess of 609.6 meters (2000 feet), 0.6 to 1.8 meters (2 to 6 feet) of water sensitive fireclay in the floor and massive sandstones in the roof, horizontal stress orientation and bottom of coal elevations were all contributing...

... is of great importance for future studies and applications, adding up previous knowledge to new scenarios. wellbore integrity Artificial Intelligence enhanced recovery Reservoir Characterization waterflooding overburden layer thickness Upstream Oil & Gas integrity assessment Thickness...

... ABSTRACT: Multi-scale numerical geomechanical models for reservoir and overburden deformation in the Tyra chalk field (Denmark) were made, and calibrated by laboratory deformation tests and field data. The mechanical interaction between the compacting and deforming formation, cement...

... ABSTRACT: A multi-scenario geomechanical modeling approach is presented to investigate the potential mechanisms that lead to a series of observed well deformation incidents in the deep overburden overlying a depleting and compacting chalk reservoir in the North Sea. Complementary...

... ABSTRACT: Fluid production from or injection into a subsurface reservoir leads to stress pressure changes inside and outside the reservoir. The overburden often consists of low permeability shale, and the undrained pore pressure response may be estimated from Skempton’s empirical equations...

... eastern and western U.S. mines. Reservoir Characterization US government Artificial Intelligence reservoir geomechanics esterhuizen Ground Control subsidence pillar overburden coal material proceedings gob parameter mining strength sandstone MPa metals & mining field...

... in the overburden. This paper presents the results of a case study in which the 5.3 local magnitude seismic event associated with a documented mine collapse is correlated with the results of a numerical simulation through calculations of released kinetic energy. The approach includes a calibration of strain...

...-production changes of the overburden. In this paper, a comprehensive 3D geomechanical model is presented that was used as a key design foundation for safe HP/HT well delivery. The model results and interpretations are discussed, and a summary of the current understanding of the evolution of the overburden...

... design, which initially estimated almost no drilling window using a linear-elastic assumption; a mismatch with a field drilling experience. In the end, applicability of calculated plasticity on the collapse gradient is discussed. wellbore integrity overburden stability analysis extension...

..., and sequestration of CO 2 and hazardous waste. Predicting and mitigating out-of-zone fluid migration includes but goes beyond maintaining well integrity: it relies on technical understanding of top and fault seals, reservoir and overburden deformation, production/injection-induced stress changes, reservoir...

... of migration of CO 2 from geological storage units. Some of these methods are already utilized for real cases of leaking CO 2 , while some of them are tested only at the laboratory scale. remediation flow in porous media chemical flooding methods hydraulic fracturing land reclamation overburden...

... the overburden and the pore pressure. 1. INTRODUCTION In the last five years, unconventional reservoirs in Argentina, particularly in the Neuquen Basin, have been intensively developed, mainly for the needs to have new sources of hydrocarbons to supplement the production of the already exploited...

... Abstract Stability of large room-and-pillar panels, which is a function of mechanical response of typically large number of pillars and deformation of the overburden on the scale of the entire panel, could be a challenging problem to analyze because it requires consideration of deformation...

... for long time periods. If backfilling of the repository rooms is taken into account, the frac criterion is satisfied too. reservoir geomechanics modeling Reservoir Characterization overburden solid waste management calculation southern part dilatant rock zone frac criterion geological...

... of the geomechanical model. Differentiation of geomechanical units in the numerical models is based on a detailed lithological analysis of the reservoir, top seal and the overburden. Lithologies can often be resolved with a great degree of confidence using cut-offs on gamma-ray and sonic logs. Experimental and field...

... and the overburden, and to improve history-matching, reserve estimation, and production forecast. With 1.3 million grid cells and 56 layers in the geomechanical model, different coupling schemes have been investigated and compared to recommend the most effective approach. The model is calibrated using multiple...